Philips 40PFL4708 Pixel characteristics, Warranty, Federal Communications Commission Notice

Page 5

1 Notice

Trademarks are the property of Koninklijke Philips N.V. or their respective owners.

P&F USA reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly.

The material in this manual is believed adequate for the intended use of the system. If the product or its individual modules or procedures are used for purposes other than those specified herein, confirmation of their validity and suitability must be obtained. P&F USA warrants that the material itself does not infringe any United States patents. No further warranty is expressed or implied.

P&F USA cannot be held responsible neither for any errors in the content of this document nor for any problems as a result of the content in this document. Errors reported to P&F USA will be adapted and published on the P&F USA support website as soon as possible.

Pixel characteristics

This LCD product has a high number of color pixels. Although it has effective pixels of 99.999% or more, black dots or bright points of light (red, green or blue) may appear constantly on the screen.This is a structural property of the display (within common industry standards) and is not a malfunction.

Warranty

No components are user serviceable. Do not open or remove covers to the inside of the product. Repairs may only be done by Service Centers and official repair shops. Failure to do so shall void any warranty, stated or implied.

Any operation expressly prohibited in this manual, any adjustments or assembly procedures not recommended or authorized in this manual shall void the warranty.

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio or television technician for help.

Declaration of Conformity

Trade Name :

PHILIPS

Responsible Party :

P&F USA, Inc.

Model :

50PFL3708, 46PFL3708, 40PFL4708,

 

40PFL1708, 39PFL2708, 32PFL3508,

Address :

32PFL4508, 29PFL4508, 24PFL4508

PO Box 2248, Alpharetta, GA 30023-2248

 

U.S.A.

Telephone Number : 1 866 309 5962

5

Modifications

This apparatus may generate or use radio frequency energy. Changes or modifications to this apparatus may cause harmful interference unless the modifications are expressly approved in the User Manual. The user could lose the authority to operate this apparatus if an unauthorized change or modification is made.

Cables

Connections to this device must be made with shielded cables with metallic RFI / EMI connector hoods to maintain compliance with FCC Rules and Regulations.

Canadian notice

CAN ICES-3 (B)/NMB-3 (B)

Standard Television Receiving Apparatus, Canada BETS-7 / NTMR-7.

Copyright

All other registered and unregistered trademarks are the property of their respective owners.

The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries.

Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories.

is a trademark of SRS Labs, Inc. TruSurround XT technology is incorporated under license from SRS Labs, Inc.

SRS TruSurround XT® creates a truly immersive surround sound experience with rich bass and clear dialog from only two speakers.

*SRS TruSurround XT technology is supported in 40PFL4708, 39PFL2708, 32PFL3508, 32PFL4508, 29PFL4508, 24PFL4508 only.

ENERGY STAR® is a joint program of the U.S. Environmental Protection Agency and the U.S. Department of Energy helping us all save money and protect the environment through energy efficient products and practices.

Consumer Notice:

This TV has been set to maximize energy efficiency while delivering the best possible picture using the factory installed home mode settings. Changing or enabling other features in this TV (e.g. brightened backlighting) will possibly increase energy consumption beyond the original ENERGY STAR® qualified limits.

LED backlighting technology uses less energy when compared with a standard CCFL backlighting LCD television of the same screen size. Actual energy savings will vary depending on the screen size.

Portions of this software are copyright © The FreeType Project (www.freetype.org).

The American Academy of Pediatrics discourages television viewing for children younger than two years of age.

English

Image 5
Contents Register your product and get support at Contents CE.org/safety Wall Mount Bracket Kit Warranty Pixel characteristicsFederal Communications Commission Notice Declaration of ConformityRegulatory notices Positioning the TVEnvironmental care End of life directivesGet started FeaturesSupplied accessories Attaching the base Stand assemblySlide the battery cover off the back of the remote control Installing the remote control batteriesManaging cables Slide the cover back into positionRemote control Terminals Control panelC d e B ePlugging in the AC power cord Connecting the antenna or the cableSelecting your connection quality Connecting your devicesComposite Analog Video Connection Component Analog Video ConnectionDigital Audio Output Connection DVD player Audio L/R + Video cableUSB Memory Stick PC connectionHome Initial setupIf you want to restore the picture setting Settings assistantRetry LocationAdjusting volume Switching on your TV and putting it in Standby modeSwitching channels Use your TVSleep timer Switching audio modeTo select channels Time increases the time by 30 minutes up to 120 minutesFor 43 video signal For 169 video signalFor PC Input signal EasyLink optionsProgram title Broadcast station TV screen informationProgram’s image aspect ratio Changing picture format p.20 To hide the informationDisplaying the Main Menu Use more of your TVNoise reduction Picture Color alignment NormalActive Control Black stretchAutoprogram Antenna confirmation Channel list11.1 Add channelsCaption settings Location Home Software upgradeChild and ratings lock US movie ratings lock Setting US movie and TV ratingsUS TV ratings lock AllChange PIN PC settingsCanadian English or Canadian French ratings Device list EasyLink Hdmi CECLanguage Setting your location to homeSticker Video Motion Jpeg Picture JpegYour USB Use to select the Picture or Video, then press OKUpgrading the software Upgrade your TV softwareChecking your current software version Question Answer Useful tipsUnusual picture appears and the TV does not operate TroubleshootingGlossary MaintenanceInformation Specifications Shipping charges to return defective product to Philips WarrantyKoninklijke Philips N.V Philips and Philips Shield are used under license