Philips C221S3 user manual Notational Descriptions, Important information for Burn-in/Ghost image

Page 9

1. Important

Important information for Burn-in/Ghost image

Always activate a moving screen saver program when you leave your monitor unattended. Always activate a periodic screen refresh application if your monitor will display unchanging static content. Uninterrupted display of still or static images over an extended period may cause “burn in”, also known as “after-imaging” or “ghost imaging”, on your screen.

“Burn-in”, “after-imaging”, or “ghost imaging” is a well-known phenomenon in LCD panel technology. In most cases, the “burned in” or “after-imaging” or “ghost imaging” will disappear gradually over a period of time after the power has been switched off.

Warning

Failure to activate a screen saver, or a periodic screen refresh application may result in severe “burn-in” or “after-image” or “ghost image” symptoms that will not disappear and cannot be repaired.The damage mentioned above is not covered under your warranty.

Service

The casing cover should be opened only by qualified service personnel.

If there is any need for any document for repair or integration, please contact with your local service center. (please refer to the chapter of “Consumer Information Center”)

For transportation information, please refer to “Technical Specifications”.

Do not leave your monitor in a car/trunk under direct sun light.

Note

Consult a service technician if the monitor does not operate normally, or you are not sure what procedure to take when the operating instructions given in this manual have been followed.

1.3 Notational Descriptions

The following subsections describe notational conventions used in this document.

Notes, Cautions and Warnings

Throughout this guide, blocks of text may be accompanied by an icon and printed in bold or italic type.These blocks contain notes, cautions or warnings.They are used as follows:

Note

This icon indicates important information and tips that help you make better use of your computer system.

Caution

This icon indicates information that tells you how to avoid either potential damage to hardware or loss of data.

Warning

This icon indicates the potential for bodily harm and tells you how to avoid the problem.

Some warnings may appear in alternate formats and may not be accompanied by an icon. In such cases, the specific presentation of the warning is mandated by the relevant regulatory authority.

7

Image 9
Contents Troubleshooting & FAQs Table of Contents Disconnecting Device Safety InformationCispr SytemsShould be at least 30% Immunity test KHz to 80 MHz Operation Safety precautions and maintenanceImportant information for Burn-in/Ghost image Notational DescriptionsWaste Electrical and Electronic Equipment Disposal of product and packing materialWeee Taking back/Recycling Information for CustomersDo you ever wonder how many germs thrive on your equipment? AntiMicrobialSetting up the monitor InstallationPackage contents Monitor is ready to be used as second monitor Remove the Base Stand Remove Base Stand and Base100mm Installation procedure DisplayLink Graphics Software InstallationClick I Accept, then software start to install Operating the monitorClick Advanced Configuration WDP opens How to control the displayExtend these displays Menu Option Sub-menu Option DescriptionDisplay marked 2 becomes blank Display marked 1 becomes blankMenu Description Menu Option When playing back video content Off Switches off the secondary display Optimize for VideoConfigure this feature The resolution of screen Off DisplayLink display primary MirrorTechnical Specifications TFT-LCDLED Resolution & Preset Modes MtbfRohs YES Lead-free Product Regulatory InformationGS EK1-20002011 GS mark requirement Federal Communications Commission FCC Notice U.S. OnlyCommission Federale de la Communication FCC Declaration Paikka/Ilmankierto VarningVaroitus Plassering/VentilasjonAuf der Rückwand des Gerätes befindet sich Ergonomie Hinweis nur DeutschlandNur original-Ersatzteile verwendet werden Achtung Beim Aufstellen中国电子信息产品污染控制标识要求中国 RoHS法规标示要求产品中有毒有害物质或 元素的名称及含量 China RoHSPhilips’ Flat Panel Monitors Pixel Defect Policy Customer care and warrantyPixels and Sub pixels Types of Pixel DefectsProximity of Pixel Defects Black Dot DefectsTotal bright dot defects of all types Dark subpixelCustomer Care & Warranty CountryConsumer care number Price IBA FujitsuCPS AL Shahd Computer L.L.C Contact Information for Apmea regionNo Picture Power LED not lit TroubleshootingDisconnect and reconnect the USB cable again Image appears distorted.Text is fuzzy or blurredMonitor FAQs General FAQsNot at the moment Can I use my PC on Linux/ AppleAns Montior Monitor will turn off completelyKoninklijke Philips Electronics N.V. All rights reserved