Philips CPWBS054CPWBS054 manual Have another IP Address displayed, Browser Configuration

Page 57

ENGLISH 57

C. I have another IP Address displayed

If you have another IP address listed then the PC may not be configured for a DHCP connection. Please refer to “Configuring Client TCP/IP” for information.

Once you have confirmed your computer is configured for DHCP, then please follow the steps below.

1.Open a DOS window as described above.

2.Type ipconfig/release.

3.Then type ipconfig/renew.

D. The 10/100 LED does not light after a connection is made.

1.Check that the host computer and the Wireless Base Station 11g are both powered on.

2.Be sure the network cable is connected to both devices.

3.Verify that Category 5 cable is used if you are operating at 100 Mbps.

4.Verify that the length of any cable does not exceed 100 m (328 ft).

5.Check the network card connections.

6.The RJ-45 port on the Wireless Base Station 11g, network card, or cable may be defective.

E. Browser Configuration

Confirm your browser is configured for a direct connection to the Internet using the Ethernet cable that is attached to the computer.This is configured through the options/preference section of your browser.

Image 57

Contents Wireless Base Station 11g Page Finnish EnglishHelpline Table of Contents Packaging contents Wireless Base Station 11gReset button Your Wireless Base Station 11gPower Indicator LEDsImportant information Safety PrecautionsEnvironmental information DisclaimerInstalling the Wireless Base Station How to use the Setup program How to create a wireless network How to create a wired network using Ethernet cablesStation 11g Installing TCP/IP Instaling and Configuring TCP/IPConfiguring a Macintosh Computer Windows 98SE/Me/2000 and XPDisable Proxy Connection Configuring the Wireless Base Station 11gView statistics to monitor network activity Running the latest firmware versionAccessing the Wireless Base Station setting menus Making Configuration Changes Setup, virtual DMZ hosts, and other advanced functionsNavigating the Web Browser Interface DSL modemTime Zone Setup WizardBroadband Type Cable ModemPPPoE xDSL Fixed-IP xDSLPptp Point-to-Point Tunneling Protocol Click Finish to complete the setupMenu Description Advanced SetupSystem Password SettingsRemote Management Internet SettingsBase Station 11g Parameters for the selected connection typePoint-to-Point Tunneling Protocol Pptp Point-to-Point Over Ethernet PPPoEStatic IP Local netwerk LAN Channel and Ssid WirelessEncryption Network Address Translation NAT Address MappingVirtual Server Special Applications Firewall Access ControlAddress for the client PCs As shown in the following screenParental Control MAC Filtering TableSchedule Rule Enables Schedule-based Internet access controlIntrusion Detection Use this section to create your network schedule rulesDMZ Demilitarized Zone Ddns Dynamic DNS Settings Tools Configuration Tools Tools Firmware UpgradeTools Complete when the power LED stops blinking Tools RebootStatus Following items are included on this screenSection Description Wireless Base Station’s configuration menu How to secure the Wireless Base Station 11g?Click ‘System’ Click ’Password Settings’ English Setting an encryption for your wireless network English Click ‘Apply’ to start using the encryption Take note of your passphrase and encryption settingsWireless Base Station 11g Your wireless network adapterYou will need to run the Setup program on the CD again For Windows XP and Windows How to set-up a computer network?English Wizard Network Settings Wizard Network Setup appears. Click ‘Next’ to continueEnglish English English For Windows 98SE and Windows Me English English English Troubleshooting Verify your connection to the Wireless Base Station 11gAm getting an IP Address that starts with Browser Configuration Have another IP Address displayed10/100 LED does not light after a connection is made Specifications RF Power Channel RF Output PowerOperating Sensitivity0682