Specifications, Electrical, Mechanical | Philips DSATX 220 instruction

5. Specifications

Input Voltage (Operating)	6-24 Volts Non-Regulated
Input Voltage (Full Load)	8-16 Volts Non-Regulated
Input Current	20A (20A mini-blade fuse)
Output Power	220 Watts Max
No Load Operating Current	< 70mA
Sleep Current (All Rails Off)	< 4mA
Efficiency	> 95%

Individual Supply Outputs	Max Output Current
5.0 Volts +/- 2%	12 Amps Nominal, 13 Amps Peak
3.3 Volts +/- 2%	10 Amps Nominal, 11 Amps Peak
12.0 Volts +/- 2%	12 Amps Nominal, 15 Amps Peak
5.0 Volts Standby +/- 2%	1.5 Amps
-12.0 Volts +/- 10%	100 mA

Electraical I/O Specifications
ACC Input Threshold	Low = < 4V, High = >7V (30V Max)
ACC Input Impedance	100k Ohms
MB Power Switch Output Drive	Open Collector, 50mA Max
AUX Output Drive	Open Collector, 50mA Max
User Switch Pull-Up Drive	10k Ohms to 5V
Serial Port Rx/Tx	Low = < 0.7V, High = >2V (5V Max)

Supervisor Specifications (Basic Mode)
P1 - Countdown Timer Range	0-20 minutes (10 minutes default)
P2 - Low Voltage Cutout Range	10-12 volts (11 volts default)
Operating Temperature Range	-40 to +90 degrees Celsius
Controlled Temperature Range	-10 to +55 degrees Celsius
MB Turn On Delay	1 second
MB Power Switch Duration	1 second
Max Shutdown Timer Range	90 seconds

5.2.	Mechanical
Mechanical Specification
Board Dimmensions		4.15"L x 3.5"W x 1.0"H (106x99mm)
Mounting hole corridnates (in)		(0.2, 0.2) (0.2, 3.3) (3.5, 3.3) (3.5, 0.2)
Mounting hole size (in)		0.125
Board Thickness (in)		0.062

DSATX Manual

Page 11 of 13