Dayton 1P579F specifications Dayton Marine Utility Pump, Description, Unpacking, Specifications

Operating Instructions and Parts Manual 1P579F

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by obeying all Safety Information. Failure to comply with Instructions could result in personal injury and/or property damage! Retain instructions for future reference.

Dayton™ Marine Utility Pump

Description

Dayton marine utility pump is designed for general commercial and industrial applications. Unit is designed for water, but is not submersible. For use transferring liquids, emptying or filling tanks, sinks or bowls. The pump can be used to pump bilge water, but the pump must not be located in the bilge area. Self-priming to 7 ft. if the impeller is initially wet (primed). Intermittent duty. Carrying handle included.

NOTE: Unit is NOT RECOMMENDED for use with soap detergents, gasoline, waste oil, fuel oil, flammable, explosive or combustible liquids or other fluids not compatible with pump component materials. Do not use unit in enclosed areas. Intermittent duty only (15 minutes per hour).

Unpacking

When unpacking the unit, inspect carefully for any damage that may have occurred during transit. Check for loose, missing, or damaged parts. Two extra impellers and gaskets are included with pump.

Specifications

Power supply required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .115V, 60Hz Fuse requirement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Amps Maximum liquid temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .140°F Minimum liquid temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40°F Thermal protection . . . . . . . . . . . . . . . . . . . . . . . . . . . .Automatic Resetting Motor amps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.60 Amps Duty Cycle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Intermittent

Dimensions

Figure 1 - Dimensions

E

N G L I S H

E

S

P

A

Ñ

O

L

F

R

A N

Ç

A

I

S

Form 5S5193	Printed in U.S.A.	998327
Rev. 01/2005	05655
	1204/399/VCPVP