SINGLE/DUAL USB-CAT5 EXTENDER 165FT
2.Plug the other end of the Category 5 UTP cabling into the Link port on the Remote Unit.
3.4.2With Premise Cabling
1.Plug one end of a Category 5 patch cord (not included) into the Link port on the Local Unit.
2.Plug the other end of the patch cord into the Category 5 information outlet near the host computer.
3.Plug one end of the second Category 5 patch cord (not included) into the Link port on the Remote Unit.
4.Plug the other end of the second patch cord into the Category 5 information outlet near the USB device.
NOTE
The maximum length of the Category 5 UTP cable, including patch cords, must not exceed 50 meters.
3.5Checking the Installation
1.Check that the Link LEDs on both Local Unit and Remote Unit are on.
3.6Connecting a USB Device
1.Install any software required to operate the USB device. Refer to the documentation for this device, as required.
2.Connect the USB device to the Device port on the Remote Unit.
3.Check that the Host LED on Local Unit is on.
4.Check that the Device LED on Remote Unit is on.
12 |