6 x 4 ELECTRONIC SCSI SWITCH
•If the last device on the chain has two SCSI connectors, attach the cable to one and a terminator to the other. Otherwise you’ll have an open connector that may cause noise on the SCSI chain.
•Always turn off the power to your computer and SCSI devices before swapping cables or moving devices around. SCSI cables contain sensitive data transmission lines and one or more live power wires.
•Turn on your SCSI devices before you turn on the computer. Some SCSI devices will not mount if they are not running when you power up your computer. Shutting down your computer first and then the attached SCSI devices allows your system to completely “flush” itself.
6.3 SCSI Interface Signal Descriptions
A total of 18 signals are required for the SCSI interface. These signals are described as follows:
•BSY (BUSY): An
•SEL (SELECT): An
•C/D (CONTROL/DATA): A signal driven by a target that indicates whether Control or Data information is on the data bus. True indicates Control.
•I/O (INPUT/OUTPUT): A signal driven by a target that controls the direction of data movement on the data bus with respect to an initiator. True indicates input to the initiator. This signal is also used to distinguish between Selection and Reselection phases.
•MSG (MESSAGE): A signal driven by a target during the Message phase.
•REQ (REQUEST): A signal driven by a target to indicate a request for a REQ/ACK
•ACK (ACKNOWLEDGE): A signal driven by an initiator to indicate an acknowledgment for a REQ/ACK
•ATN (ATTENTION): A signal driven by an initiator to indicate the Attention condition.
•RST (RESET): An
•DB0 through DB15, P, P1 (DATA BUS): Sixteen
40