Xerox 701P40210 manual User TRC setup window, Expert color tools

Page 39

Using color tools

Figure 4-5. User TRC setup window

Create User TRCs to make and save color adjustments that can be applied to jobs. The creation of User TRCs should be performed by users with a high level of color knowledge.

For example, create a TRC that compensates for jobs submitted from a specific device that generates a consistent magenta tint. A TRC adjusting for that tint could be created and applied to every job submitted from that device. This saves job preparation time and assures that the same adjustment is made to all jobs submitted from that device.

Expert color tools

Skilled users employ expert color tools for high level color adjustments. Users select source and destination color profiles to be used in conversion to engine CMYK.

Usage of the expert color tools is dependent upon your color requirements. You can use these tools to improve color quality.

•Source color allows you to select RGB, CMYK and Gray input color profile for the image, on an object-type basis.

Color Management Guide

4-5

Image 39

Contents

Color Management USA Table of contents Troubleshooting Using color toolsAbout this guide IntroductionAssumptions Multiple print enginesConventions Related documentationCustomer Support Introduction Color Management Guide Queue overrides DocuSP color managementColor workflows Color path chartsSimplified DocuSP Color Workflow ICC standard path Xerox enhanced path Cmyk Native path Fast Reprint pathPantone path Color Manager User TRCs Print engine specific modeColor tools Color profilesQueue Property Queue Setting DocuColor 2045/2060/6060 mode default Property settingsXCC mode default and override settings Xerox consistent color modeCustom color mode default Color adjustmentsImage quality tools Expert color Image ResampleNearest neighbor Bi-linear Smart Spot color editor Output Destination Profiles convert PCS to CmykOPI Open PrePress Interface DRIs Display Resolution ImagesDocuSP color management Color Management Guide Characterization Stock Management and CalibrationPage Tips for use of Xerox Qualified Stocks Calibration process overviewCalibrating the DocuColor 2045/2060/6060 family Calibrating the DocuColor iGen3Calibration target tips Calibration target and whitespace Calibration step Key Points to this approach Stock Management hints and tipsCalibrate ANY stock named Unspecified Setup Steps after software installationThree Stock Model Setup RecommendationsAdding New Stock Non-Xerox Adding a Xerox Qualified StockDocuSP Sample Stock Grouping Custom and Colored Stock hints Page Using Custom color mode default Using color toolsLightness, Contrast, and Saturation color Controls Basic color toolsColor Cast controls User Tonal Reproduction Curves TRCs Black overprintExpert color tools User TRC setup windowExpert Color Source Color dialog Interpolation methods Rendering EmulationSystem Specified Defaults Spot Color Editor tab Understanding the Spot Color Editor windowOpen PrePress Interface OPI OPI setup dialog Using XCC Xerox Consistent Color mode Using Print Engine Specific mode11. Selecting XCC mode Image paths TroubleshootingThings to remember Table A-1 System Specified defaultsSystem Specified defaults Glossary Of Color Management Terms Page Page Page Index Page