Xerox 510DP Problem solving table, Problem-Solving Table Condition Causes Suggested Solutions

PROBLEM SOLVING

Problem solving table

The table below lists some conditions that may occur during the operation of the printer. You may be able to resolve the problems by following the suggested solutions in the table. For problems beyond the scope of this table, call for service.

Table 4. Problem-Solving Table

Condition	Causes	Suggested Solutions
Portions of the prints are deleted.	The media may be damp.	Check the condition of the media. If
		damp, replace it.
		Store the media in a sealed
		package or bag.
The prints are light overall or have	The print density may be too light.	Use the Printer Menu to adjust the
light areas.		print density. Refer to "Adjusting
		the print density" in this manual.
	The media may be too damp.	If media is damp, replace it.
		Use a sealed media drawer.
		Store the media in a sealed
		package or bag.
The tracing paper has wrinkles.	The media may be too dry.	Use a sealed media drawer.
		Store the media in a sealed
		package or bag.
Image is missing on left and right	When using the Scale-to-fit option	Do not use a zero margin setting
sides of the print when using the	the margins may have been set 0	when using Scale-to-fit. Try adding
Scale-to-fit option	(zero)	a margin and increasing it, if
		necessary, until the image is on the
		print.

46 XEROX WIDE FORMAT 510dp OPERATOR MANUAL