Xerox 510DP manual Using the cut sheet feed-in shelf

MEDIA

Using the cut sheet feed-in shelf

When the correct media size or type is not loaded in the printer, you can bypass the media drawers and manually load cut sheets into the printer.

If large size cut-sheet prints, portrait D-size (A1) oe E-size (A0), are being made, return to the Printer and guide the lead edge of the print as it exits the Printer to prevent the print from jamming at the exit. With the Output Tray in the raised position, the prints could feed back into the Printer.

To manually feed cut sheets into the printer:

1.Raise the output tray all the way until it rests on top of the printer.

2.Select the appropriate cut sheet for the print job.

NOTE: The minimum size for a cut sheet is 8-1/2 x 11 inches (216 x 279 mm) fed short edge lead.

3.Set the BYPASS media type on the printer control panel to the correct one for the print job. See "Changing the roll media size and type" for further information.

NOTE: The printer will accept whatever media type you manually feed into it, regardless of the media type you specify. You should ensure that the media type is correct, however, as the printer uses the media type to determine the fuser temperature. The wrong fuser temperature could cause poor print quality. It could also result in a maintenance service call, if any toner rubs off the media onto the fuser roll.

4.Center the media between the size indicators on the cut sheet feed-in shelf.

5.Feed the lead edge of the media squarely into the printer until the printer grabs and advances the media.

6.From the client workstation, specify Manual Feed as the media source.

7.Submit the print job.

8.When you are finished manually feeding cut sheets, lower the output tray.

16 XEROX WIDE FORMAT 510dp OPERATOR MANUAL