Safety Instructions, Read Before Installation

Safety Instructions

Antenna grounding and safety warning

Warning Installation of this product near power lines is dangerous. For your safety, keep ladder and antenna away from power lines. Contact may cause electrocution.

1 . Outdoor antennas and lead-in conductors from antenna to a build- i n g , should not cross over open conductors of electric light or p ower circ u i t s .T h ey should be kept aw ay from all circuits to avo i d the possibility of accidental contact.

2 . Each conductor of a lead-in from an outdoor antenna should be connected with an antenna discharge unit.Antenna discharge units (or Lightning A rrestor) should be located outside the building or inside the building between the point of entrance of the lead-in and the T V, and as near as practical to the entrance of the conductors to the building.

NEC - National Electrical Code

*Antenna Discharge Unit is not required if lead in conductors are enclosed in a con- tinuous metallic shield that is permanently and effectively grounded.

IMPORTANT

READ

BEFORE

INSTALLATION

Important Safety Notes

If you do not feel comfo rtable or competent to install this antenna we recommend that you seek the assistance of a qualified pro fe s s i o n a l antenna installer.

Read the instructions for this device thoro u g h ly befo re attempting i n s t a l l a t i o n .

The installation or dismantling of any antenna near power lines is dan- g e ro u s . Each year hundreds of people are killed or injured while attempting to install or service antennas. For your safety and pro p e r antenna installation, read and fo l l ow all safety pre c a u t i o n s .

Choose an installation site for safety as well as performance.

All electric power lines, cable lines and telephone lines look alike.To be safe, assume ANY overhead line can kill yo u .

Do not place an antenna where it could potentially fall on to, or blow into a power line. If in doubt call your electric prov i d e r. Let them rev i ew your site.

Outdoor antennas should be grounded with an ap p roved lighting arre s t- ing device.Local codes may ap p ly. Use 8 AWG or larger ground wire.

Height or other restrictions on antennas may ap p ly to your installa- tion depending on your proximity to an airport, or local ord i n a n c e s .