Belkin F5D7001 user manual Activity LED green, Link LED orange, Card Connector

Page 10

Overview

(d)

(c)

(b)

(a)

(a) Activity LED (green)

Indicates wireless activity when blinking.

(b) Link LED (orange)

Lights up when the Card links to a wireless network.

(c) Card Connector

Indicates the side of the Card that fits into your computer’s PCI slot.

(d) Detachable Antenna

Product Specifications

Host Interface:

32-bit PCI

Power Consumption:

Tx/Rx peak 550/350mA@3.3VDC (max.)

Certification:

FCC Class B, CE Mark, C-Tick

Operating Temperature:

32–185 degrees F (0–85 degrees C)

Storage Temperature:

-40–194 degrees F (-40–90 degrees C)

Humidity:

Max. 95% (non-condensing)

Typical Operating Range:

Up to 200 feet (Wireless performance

 

may vary depending on the

 

networking environment)

8

Page 9 Page 11
Image 10
Page 9 Page 11
Contents
High-Speed Mode Wireless G Desktop Network Card Table of Contents Introduction Introduction Cordless Phone Placement Avoid Obstacles and InterferenceChoose the quietest channel for your wireless network Secure connections, VPNs, and AOLIntroduction Product Features OverviewCompatibility with 802.11b products Connection rates of up to 54Mbps or 125Mbps* using HSMDifficult-to-wire environments Frequently changing environmentsActivity LED green Card ConnectorDetachable Antenna Product Specifications Link LED orangePackage Contents System RequirementsInstalling and Setting Up the Card Install the SoftwareInsert the Card into the Computer Installing and Setting Up the Card Let Windows Finish the Installation Installing and Setting Up the Card Installation is now complete Click on the Wireless Networks tab Enable Radio Setting Wireless Network PreferencesAvailable Networks System Tray Icon Preferred NetworksAdd, Remove PropertiesAccess Point Infrastructure Networks Only Any Available Network Access Point PreferredComputer-to-Computer Ad-Hoc Networks Only Securing your Wi-FiNetwork Bit WEP WEP Wired Equivalent PrivacyEncryption Keys WPA Wi-Fi Protected Access C3030FAF0F4BB2C3D44BC3D4E7 = 128-bit WEP keyUsing a Hexadecimal Key Changing the Wireless Security Settings WEP Setup Bit WEP EncryptionC3030FAF0F4BB2C3D44BC3D4E7 = 128-bit WEP key WPA-PSK no server WPA with server Settings Using the Belkin Wireless LAN Utility Type your WEP key in the Network key box Using the Belkin Wireless LAN Utility Using the Belkin Wireless LAN Utility Monitoring the Status of your Network Connection Network Connection Type SignalClient IP Address Radio StateMonitoring Data Transfer Click on the Statistics tabFinding Available Networks in your Area Control Registers Performing Diagnostic Tests on your ConnectionClick on the Diagnostics tab Sprom Format VersionLoopback Test Interrupt TestLED Test Troubleshooting Can’t connect to the Internet wirelesslyName of your wireless network appears in Available Networks Installation CD-ROM does not start Setup Utility Power LED does not come on Card is not workingLink LED is solid but cannot connect to the Internet Signal strength is poor Data transfer is sometimes slowTroubleshooting Wireless PCI Card is not Detected by Operating System Wireless Comparison What’s the difference between 802.11b, 802.11g and 802.11a?Technical Support Europe 00 800 223 55 US +1FCC Statement Federal Communications Commission NoticeInformation Belkin Corporation Limited Lifetime Product Warranty Belkin GmbH
Related manuals
Manual 52 pages 23.2 Kb Manual 52 pages 22.48 Kb