Belkin F5D7001 user manual WPA-PSK no server

Page 28

Using the Belkin Wireless LAN Utility

WPA-PSK (no server)

Choose this setting if your network does not use a radius server. WPA-PSK (no server) is typically used in home and small office networking.

1.From the Security Mode drop-down menu, select “WPA-PSK (no server)”.

2.Enter your network key. This can be from 8 to 63 characters and can be letters, numbers, or symbols. This same key must be used on all of the clients (network cards) that you want to include in your network.

3.Click “Apply Changes” to finish. You must now set all clients (network cards) to match these settings.

26

Image 28

Contents High-Speed Mode Wireless G Desktop Network Card Table of Contents Introduction Introduction Cordless Phone Placement Avoid Obstacles and InterferenceChoose the quietest channel for your wireless network Secure connections, VPNs, and AOLIntroduction Product Features OverviewConnection rates of up to 54Mbps or 125Mbps* using HSM Difficult-to-wire environmentsCompatibility with 802.11b products Frequently changing environmentsCard Connector Detachable Antenna Product SpecificationsActivity LED green Link LED orangePackage Contents System RequirementsInstalling and Setting Up the Card Install the SoftwareInsert the Card into the Computer Installing and Setting Up the Card Let Windows Finish the Installation Installing and Setting Up the Card Installation is now complete Click on the Wireless Networks tab Enable Radio Setting Wireless Network PreferencesAvailable Networks Preferred Networks Add, RemoveSystem Tray Icon PropertiesAccess Point Infrastructure Networks Only Any Available Network Access Point PreferredComputer-to-Computer Ad-Hoc Networks Only Securing your Wi-FiNetwork Bit WEP WEP Wired Equivalent PrivacyEncryption Keys WPA Wi-Fi Protected Access C3030FAF0F4BB2C3D44BC3D4E7 = 128-bit WEP keyUsing a Hexadecimal Key Changing the Wireless Security Settings WEP Setup Bit WEP EncryptionC3030FAF0F4BB2C3D44BC3D4E7 = 128-bit WEP key WPA-PSK no server WPA with server Settings Using the Belkin Wireless LAN Utility Type your WEP key in the Network key box Using the Belkin Wireless LAN Utility Using the Belkin Wireless LAN Utility Monitoring the Status of your Network Connection Signal Client IP AddressNetwork Connection Type Radio StateMonitoring Data Transfer Click on the Statistics tabFinding Available Networks in your Area Performing Diagnostic Tests on your Connection Click on the Diagnostics tabControl Registers Sprom Format VersionLoopback Test Interrupt TestLED Test Troubleshooting Can’t connect to the Internet wirelesslyName of your wireless network appears in Available Networks Installation CD-ROM does not start Setup Utility Power LED does not come on Card is not workingLink LED is solid but cannot connect to the Internet Signal strength is poor Data transfer is sometimes slowTroubleshooting Wireless PCI Card is not Detected by Operating System Wireless Comparison What’s the difference between 802.11b, 802.11g and 802.11a?Technical Support Europe 00 800 223 55 US +1FCC Statement Federal Communications Commission NoticeInformation Belkin Corporation Limited Lifetime Product Warranty Belkin GmbH

Related manuals

Manual 52 pages 22.48 Kb