Belkin F1DS102U, F1DS104U user manual Installing the HID USB Driver, Connecting the Console

Page 7

STEP-BY-STEP INSTALLATION GUIDE

Installing the HID USB Driver

Note: On some computers, you must enable USB support on your system BIOS. Please reference your computer manufacturer’s manual or motherboard manual to verify that USB support is enabled.

1.Connect the 9V, 1A power adapter to the KVM Switch.

2.Boot up the computer you wish to connect via USB as you would normally with the USB keyboard, monitor, and USB mouse connected directly to the computer.

3.After the operating system finishes loading, using a standard USB A- to-B cable, insert the end with the B-type connector to the

KVM Switch. Insert the other end of the cable with the A-type connector to an available port on your USB computer. Your computer should recognize your KVM Switch and automatically install the HID USB driver. Once the driver is installed, you can power down your computer.

4.Repeat steps 1 through 3 for each additional USB computer you wish to connect to the KVM Switch.

STEP-BY-STEP INSTALLATION GUIDE

Connecting the Console

1.Power down your computers.

2.Remove the rear panel of the KVM Switch to expose the ports.

3. Connect the USB keyboard to the designated USB

port with the keyboard symbol on the KVM Switch.

Note: You must connect the USB keyboard to the designated USB connector to have keyboard hot key switching functions.

For more information on keyboard hot keys, see page 14.

4. Connect the USB mouse to the designated USB port

with the mouse symbol on the KVM Switch.

5.Connect any USB devices

you wish to share to the USB hub labeled “Device 1, Device 2” on the KVM Switch.

Note: When sharing USB storage devices, CD-RWs, or hard drives, do not switch while operating.

6. Connect the monitor cable to the designated “Console VGA” port on the KVM Switch.

10

11

Image 7
Contents OmniView Introduction Table of ContentsOverview Platforms Power SupplyFront of the KVM Switch CablesBack of the KVM Switch Where to Place the KVM SwitchCable Distance Requirements Warranty 5 years Installing the KVM Switch BaseDimensions WeightConnecting the Console Installing the HID USB DriverConnecting the PCs Selecting a Computer Using Keyboard Hot Key Commands Using Your Soho Series USB KVM SwitchPowering Up the Systems Selecting a Computer Using Direct-Access Port SelectorsOmniView KVM Switches OmniView E Series Belkin KVM Switches and AccessoriesAutoScan Mode Connecting USB Devices to the Built-In 2-Port HubOmniView E Series KVM Cables OmniView PRO2 Series with On-Screen DisplayOmniView MATRIX2 Series with Dual-Console Control OmniView KVM CablesOmniView Daisy-Chain Cables OmniView PRO Series Plus All-In-One KVM CablesOmniView Matrix Series All-In-One KVM Cables OmniView Gold Series All-In-One KVM CablesOmniView KVM Accessories and Adapters FAQsTroubleshooting FAQsKeyboard FCC Statement Belkin Corporation Limited Five-Year Product WarrantyCE Declaration of Conformity