Barco II manual Sysmgr, Uinput

SYSMGR

Description: System Manager Settings

Parameters:
--blkinv (Black Invalid Mode)	: 0=OFF, 1=ON
--vfd (VFD Brightness)	: 0..6
--opmode (Operation Mode)	: 0=SingleChannel, 1=DualChannel,
	2=3DProcessing

Note: For the new operating take full effect, you must save settings and reboot the

unit.
--conmode (Encore Connect Mode)		: 0=OFF, 1=ON
--unitid (Encore Unit ID)		: 1..32
--encoreip (Encore IP address)		: xxx.xxx.xxx.xxx
Query Format: SYSMGR --?
Query Response:	System Manager Settings in the following format
SYSMGR --blkinv (Black Invalid Mode) --vfd (VFD Brightness) --opmode
(Operation Mode) --conmode (Encore Connect Mode) --unitid (Encore Unit ID)
--encoreip (Encore IP Address)

UINPUT

Description: Input Settings

Required parameters: --con (connector)

--itype (input type), for commands to DVI input settings

Parameters:
--con (connector)		: [0..5], see below for connector numbers.
--itype (input type)			: 0 = digital, 1 = analog
--deint (deinterlacing type)			: 0 = MotionAdaptive, 1 = FieldToFrame
--motion (motion threshold)			: [0..15]
Examples:
UINPUT --con 0 --	itype 0	--deint 0
(Update DVI (digital in) input, deinterlacing type to Motion Adaptive
Query Format: UINPUT --		con (connector) --?
Query Response:	Input Settings in the following format

UINPUT --deint (deinterlacing type) --motion (motion threshold)

Connectors:

0=DVI

1=HD15

2=HDMI

3=DP

4=SDI1

5=SDI2 (available when Dual option mezzanine installed)

26-0904001-00 Rev 00.00 16