4. General Operation
1)In addition to the input and output connectors provided in
2)When switching from Single mode to Dual2K mode, the user will be prompted to take corrective action if the following items are not setup correctly. Until these items are corrected, the unit will not be allowed to enter Dual2K mode.
a.ALL Inputs connected to the
b.Resolution/frame rates programmed for ALL input EDIDs must not exceed the maximum pixel rate of 165MHz.
c.The current Output resolution/frame rate selection must not exceed 2048x1200@60.
3)After the mode has been changed from Single mode to Dual2K mode, the following will be true:
a.Channel A and Channel B are both configured to match the Single mode configuration as defined prior to entering Dual2K mode.
b.All output connectors are assigned to Channel A.
c.A Logo saved in Single mode will be available for both Channel A and Channel B.
d.Channel B Genlock will default to “Lock to A”
4)When in Dual2K mode,
a.The maximum Output Resolution for each channel is 2048x1200@60.
b.The maximum Logo Resolution is 2048x1200.
c.Input maximum pixel rate can not exceed 165MHz
5)Source Transitions, Freeze and Logo captures will be done synchronously on Channels A and B.
a.Note: When a Logo capture is performed, Channel A and B will perform a freeze function simultaneously and the logo images will then be captured. If the two output channels are not genlocked, it is possible that the image frozen will be 1 frame apart between the two outputs.
6)When changing the mode from Dual2K mode to Single mode, the following will happen:
a.The user will be prompted with a warning that Channel B settings will be discarded if the SEL button is pushed to “Confirm”. Pressing the “ESC” button will cancel this operation.
b.The single channel configuration will match Channel A as defined in Dual2K mode, just prior to entering Single mode.
c.All output connectors are assigned to the Single channel.
| 12 |