Barco HD/3G SDI, 3G/HD/SD-SD user manual Off

MatrixPRO-II 3G/HD/SD-SDI Routers					Rev. 1.1
	Layer 2	Input	Layer 2	Output
	1	9	1	9
	2	10	2	10
	…	…	…	…
	8	16	8	16
	Layer 3	Input	Layer 3	Output
	1	17	1	17
	2	18	2	18
	…	…	…	…
	8	24	8	24
	Layer 4	Input	Layer 4	Output
	1	25	1	25
	2	26	2	26
	…	…	…	…
	8	32	8	32

3.3SW7: Power alarm

The power alarm can be switched according to the following pattern:

SW 7	Power alarm
OFF	Disables Power Alarm
ON	Enables Power Alarm

Default setting is Power Alarm disabled.

Changing this from default setting should only be done when using two (redundant) power supplies.

3.4SW8: Power-up mode

Switch 8 on the configuration switch defines the power up mode on NxN square routers. The MatrixPRO-II router provides two modes for powering up the system.

The power up options can be switched according to the following pattern:

SW 8	Power Up mode
OFF	Switches all outputs according to the buffered information in the
	routers processor system.
ON	Switches all outputs to input 1.

Default setting switches all outputs according to the buffered information in the routers processor system.

MatrixPRO-II HD/3G SDI Series –User’s Guide - Rev. 1.1

18