Src, Dest | Barco HD/3G SDI, 3G/HD/SD-SD manual

MatrixPRO-II 3G/HD/SD-SDI Routers

Rev. 1.1

B.1 X-Point Take

This command directly takes the specified X-point. The command specifies which sources to connect to which destinations and on what levels. Several X-point takes can be specified on a single command line. In such cases all specified X-points are taken simultaneously.

Command:

x<X-points>[ : <group_no>][*CC]<LF> <LF>

Response:

%<LF>

xl<level> <src> <dest><LF> [*CC<LF>]

<LF>

Where:

<X-points>=<X-point>[ <X-points>] <X-point>=l<levels> <src_dest_pairs> <src_dest_pairs>=<src_dest_pair>[ <src_dest_pairs>] <src_dest_pair>=<src> <dests> <levels>={<level><levels>,<levels><level>-<level>} <dests>={<dest><dests>,<dests><dest>-<dest>}

<level>	The level number.
<src>	Source number in the range from zero to one less than the number of inputs
	on the level. <src> can also be one of the following characters:
	d	Disconnect. Used when a destination is not connected to any source.
	o	Out of range. Used when a destination is connected to a source not
		included in a level. This may occur with overlapping partitions. Only
		valid in the response.
	u	Undefined/Unknown. This might be used at start-up before the status
		is read from the physical router. It is also used on ported routers
		where a port can be used as an input or an output. Only valid in the
		response.
<dest>	Destination number in the range from zero to one less than the number of
	outputs on the level.

MatrixPRO-II HD/3G SDI Series –User’s Guide - Rev. 1.1