Barco HD/3G SDI, 3G/HD/SD-SD user manual Take on/off

Page 24

MatrixPRO-II 3G/HD/SD-SDI Routers

Rev. 1.1

Take on/off

The Take on/off button enables or disables the Take button. If no take button is defined, Take on/off is always off. On first start-up the take button is enabled. Later it will read the last status from the flash memory.

Take

The Take buttons LED is normally off. If the Take on/off button is set to “on”, no commands will be sent from the panel until the Take button is pressed. The last selected buttons and the take button will blink, until the Take button is pressed and the command is sent from the panel.

Output

An Output button is used for selecting an output. Selecting an output activates it, so that it is switched to the next input that is selected.

Input

An Input button switches the active output to the selected input. If the Take button is enabled, the switch will not be executed until the Take button is pressed.

When switching using the Input button, all enabled audio- and video-levels will be switched from the selected input to the active output.

MatrixPRO-II HD/3G SDI Series –User’s Guide - Rev. 1.1

24

Image 24

Contents MatrixPRO-II Copyright Trademarks Company Address Operators Safety Summary Terms in This Manual and Equipment Marking Change History Contents Appendix C Barco MPII-3G Configuration Tool Product versions 1RU, Depth 5cm2RU, depth 5cm Specifications Mechanics Weight and power consumption Device Current, +15V PowerPower Supply Control Function Description ConnectorVideo specifications Supported formats Electrical signal inputsElectrical signal outputs Signal transitionPower a Power BConfiguration SyncConfiguration Router modeRouter layers 8x8 router 16x16 router 32x32 router − 1 layerMatrixPRO-II 3G/HD/SD-SDI Routers Rev − 3 layers, based on a 16x16 router Layer Input Output − 3 layers, based on a 32x32 router Layer Input OutputMatrixPRO-II 3G/HD/SD-SDI Routers Rev OFF Switching time Configuring protocol optionsTCP/IP RS232Alarm states Description LED state Alarm CommentLED status indication Start-up Ethernet states Pin # RS-232 mode Router communication Serial connection Maximum cable length RS-232Ethernet connection Button Color Video Enabled Audio Enabled Panel EnableControl Panel operation Button description A/V Toggle Take on/off TakeEnvironmental Specifications Appendix a Materials declaration Toxic or hazardous substances and elementsPBB Pbde Recycling information Declarations of Conformity DescriptionPing LlistSrc DestRequest X-Point Status EchoCommand Ping*CCLFLF Response ? pingLF pongLF *CCLF LF Router PingAppendix C Barco MPII-3G Configuration Tool