IBM LE-565 user manual Bios Setup, 1CMOS Setup Utility Main Screen

Page 44

LE-565 User’s Manual

BIOS Setup

Chapter 4 <BIOS Setup>

The motherboard uses the Award BIOS for the system configuration. The Award BIOS in the single board computer is a customized version of the industrial standard BIOS for IBM PC AT-compatible computers. It supports Intel x86 and compatible CPU architecture based processors and computers. The BIOS provides critical low-level support for the system central processing, memory and I/O sub-systems.

The BIOS setup program of the single board computer let the customers modify the basic configuration setting. The settings are stored in a dedicated battery-backed memory, NVRAM, retains the information when the power is turned off. If the battery runs out of the power, then the settings of BIOS will come back to the default setting.

The BIOS section of the manual is subject to change without notice and is provided here for reference purpose only. The settings and configurations of the BIOS are current at the time of print, and therefore they may not be exactly the same as that displayed on your screen.

To activate CMOS Setup program, press DELkey immediately after you turn on the system. The following message “Press DEL to enter SETUP” should appear in the lower left hand corner of your screen. When you enter the CMOS Setup Utility, the Main Menu will be displayed as Figure 4-1. You can use arrow keys to select your function, press Enterkey to accept the selection and enter the sub-menu.

Figure 4-1CMOS Setup Utility Main Screen

44

Image 44
Contents User’s Manual EditionTrademark LE-565 User’s ManualDisclaimer Packing List HardwareCable Kit Printed MattersIndex Chapter1BIOS Auto Flash Tool 2Flash Method Is Left For Blank Introduction Product OverviewVGA Display Interface Product SpecificationMulti-I/O Port Power and Environment Ethernet InterfaceAudio Interface Expansive InterfaceMechanical Drawing Block Diagram Eden nanoBGA2Hardware Setup Connector LocationDcin Jumper Reference Jumper FunctionConnector Reference Internal ConnectorExternal Connector Connector Function RemarkMemory CPU and Memory Setup1 CPU Cmos ATX Setup ModeJcfsel Mode Enhanced IDE & CF InterfaceSerial ATA Interface Floppy Port LAN Interface Onboard Display Interface Onboard Display InterfaceAnalog VGA Interface Digital Display Jvlcd JvlcdPin Signal Pin DescriptionLCD Installation Guide Preparing the LS-570,LCD panel and the backlight inverterResolution Color Channel LE-565 Bios panel type selection formOnboard Audio Interface 12 USB2.0 Interface Interface USB2.0VCC Gpio Interface Serial Port Jumper Setting JCSEL1 JCSEL2JCSEL2 JCSEL11 Power and Fan Connector Power InputPin Description Ground +12V Fan Control Power OutputFan Connector Indicator and Switch PINThis Page is Left For Blank System Configuration Sata RAID ConfigurationLE-565 User’s Manual Audio Configuration Display Configuration LE-565 User’s Manual System Configuration Please select S3Display for advanced device setting LE-565 User’s Manual This Page is Left for Blank Bios Setup 1CMOS Setup Utility Main ScreenThis Page is Left for Blank Appendix a I/O Port Pin Assignment IDE PortIORDY/DDMARDY IrDA Port Serial Port CRT PortSerial ATA Port LAN Port PinThis Page is Left for Blank Flash Method Appendix B Flash BiosBios Auto Flash Tool This Page is Left for Blank Contact Information Taiwan Commate Computer Inc