The Upper panel shows technical data concerning software and hardware present on the host computer which were used to communicate over HomePlug on the Power line network. It shall include the following:
uOperating System Platform/Version
uHost Network Name
uUser Name
uMAC Address of all NICs (Network interface card) connected to the host
uIdentify versions of all Driver DLLs and Libraries used (NDIS) and optionally
uHomePlug chipset manufacturer name (Turbo Only devices)
uMAC Firmware Version (Turbo Only devices)
uMAC addresses of all devices connected locally to the host
uVersion of the Configuration Utility
The Lower panel contains a history of all remote devices seen on the computer over a certain period of time. All devices that were on the power line network are listed here along with a few other parameters. Devices that are active on the current logical network will show a transfer rate in the Rate column; devices on other networks, or devices that may no longer exist are shown with a “?” in the Rate column. The following remote device information is available from the diagnostics screen:
uOperating System Platform/Version
uHost Network Name
uUser Name
uMAC Address of all NICs (Network interface card) connected to the host
uIdentify versions of all Driver DLLs and Libraries used (NDIS) and optionally
uHomePlug chipset manufacturer name (Turbo Only devices)
uMAC Firmware Version (Turbo Only devices)
uMAC addresses of all devices connected locally to the host
uVersion of the Configuration Utility
uVendor name
About
The About screen shows the software version and Preferences setting.
Preferences
AutoScan function enable or disable.
Figure 8. About dialog screen
10 | 11 |