Star Micronics MP111MP-24G-A, MP115MP-24G-A operation manual Installation, SP2

Page 33

7. INSTALLATION

1.At the time of mounting the printer mechanism into its housing cabinet, put cushion material, such as, rubber foot, on the printer mechanism legs. If installed directly, reverberations occur producing noise. We recommend that you use the following rubber foot.

Parts name : DAMPER RUBBER

SP2

Parts No. : 30290010

Fig. 7-1 Recommended Rubber foot

Parts name : SCREW 3.0

Parts No. : 30250010

Fig. 7-2 Recommended Set screw (unit: mm)

2.Set the play between the roll paper holder and paper thrust direction to within 2 mm, and ensure that the roll paper holder doesn’t hold back the edge of paper.

3.Set the paper inserting angle to within 65° .

4.Edges around the paper insertion area should be rounded at R2 mm or more.

5.Set the paper feed load, at the printer’s paper inlet, to 30 g or less.

6.Take into account prevention of paper rewinding, when designing the case.

7.Allow needed space surrounding the printer. Fig. 7-3 shows an example of installation space.

8.Fig. 7-4 shows an example of installation.

9.Since this printer mechanism employs galvanized steel panels, the end surface doesn’t come plated.

– 30 –

Image 33

Contents MP111MP-24G-A MP115MP-24G-A Page Contents General Description Construction ConfigurationOther Principle of OperationMP111MP External view MP115MP External view General Specifications Printing SpecificationsDetails of Character Dimentions Paper spec. & Print area Paper SpecificationsMP111 Ink Ribbon SpecificationsMP115 CR Motor + CMN VH Connector SpecificationsConnector connections Half font Forward printing Print TimingPrinting Timing ChartRelease action Transistor’s turn off delay time td 2 ∝ s Print Head SpecificationsTR1 Number of character per line Dot/chara 13 Print duty specific wires 14 Current waveform of the motor CR Motor SpecificationsTR2 16 Drive circuit of paper feed motor example Paper Feed Motor SpecificationsMP115MP only Ribbon Shift Solenoid RS-SOL Specifications19 Circuit of timing signal 1 example Timing Signal Detector SpecificationsPaper-out Detector PE-sig Specifications Home Position Detector HP-sig SpecificationsDimension and Weight Ribbon Position Detector RS-sig Specifications MP115MP only24 MP111MP External dimension unit mm 25 MP115MP External dimension unit mm Reliability Specifications Setting the Ribbon Cartridge Setting the Paper Setting the PaperRemoving the Paper SP2 InstallationInstallation space example unit mm Printer installation example unit mm Page Printer installation Operational Notes Power ON/OFF NoteOther Notes Carriage Motor Protection Method Against Mechanical ErrorsPower Supply Capacity 24 V Line5 V Line Paper Guide Option OptionsDistributed by