Using the Utilities, Auto-Run Installation

Installing the Print Server

Follow these steps for a trouble-free start of print server operations with your Wireless Print Server.

1.Confirm proper operation of the printer to be connected to the print server.

2.When you have confirmed proper operation of the printer, turn off the power.

3.Confirm that your network is operating normally.

4.Connect the print server to the network (through the RJ-45 connector of the print server).

5.While the printer is powered off, connect the print server to the printer’s USB or Parallel port.

6.Turn on the printer’s power.

7.Connect the DC end of the AC Power adapter to the DC power input socket of the print server and the AC end to the wall outlet. This will supply power to the print server immediately.

NOTE:This print server is built with a default IP Address. To prevent from any conflict in your network, it is recommended to use the PS-Utility program to change the IP setting when there is some other device’s IP Address is the same as the print server’s default IP Address.

- 11 -

USING THE UTILITIES

This chapter describes the software utilities for the print server, including how to set up your print server with these utility. The PS- Utility and PS Wizard are designed with a user-friendly interface that allows you to set up and administer the print server easily.

Auto-Run Installation

Insert the Installation CD-ROM into your computer’s CD-ROM drive to initiate the Auto-Run program, and the menu screen will appear as below.

- 12 -