_________________________________________________________________________________________________________________________
Appendix 2 | AT command set |
Executing commands
Your modem is in Command Mode upon
AT commands and format
All commands must begin with the AT prefix, followed by the command letter and ended with the ENTER key. All default settings are printed in bold text. Spaces are allowed in the command string to increase command line readability but are ignored by the modem during command execution. All commands may be typed in either upper or lower case, but not mixed. A command issued without any parameters is considered as specifying the same command with a parameter of "0".
Example: ATL [ENTER]
This command causes your modem to lower its speaker volume.
AT Command Summary |
|
| |
AT | Command prefix | ||
A/ | Repeat last command |
|
|
A | Answer |
|
|
B0 | Select V.22/V.21 |
|
|
B1 | Select B212A/B103 |
|
|
B15 | Select V.21 when the modem is at 300 BPS |
|
|
B16 | Select Bell 103J when the modem is at 300 BPS |
|
|
D | Dial |
|
|
0 - 9 | Dialing digits |
|
|
ABCD*# | Tone dial characters |
|
|
L | Redial last number |
|
|
P | Pulse dial |
|
|
T | Tone dial |
|
|
V | The modem switches to speakerphone mode and dials the number |
|
|
R | The modem goes into answer mode directly after finish dialing |
|
|
S=n | Dial stored telephone number n |
|
|
W | Wait for dial tone |
|
|
| - 17 - | Rev.1.00.2.1.34 |
_________________________________________________________________________________________________________________________
AT | Command prefix |
,Pause the time specified in
! Flash hook
@Wait for quiet answer
^Disable data calling tone transmission
$ | Bong tone detection |
;Return to command mode
E0 Disables echo
E1 Enables echo
H0 Hang up the telephone line
H1 Pick up the telephone line
I0 | Reports modem identify string and driver version number |
I1 | Calculate ROM checksum and report it to DTE |
I2 | Verifies ROM checksum and report OK or ERROR |
I3 | Report modem identify string and driver version number |
I4 | Report firmware version for datapump |
I5 | Report the board/firmware ID, country ID and subsystem vendor ID |
I9 | Report country ID |
I11 | Report connection information |
L0 | Low speaker volume |
L1 | Low speaker volume |
L2 | Medium speaker volume |
L3 | High speaker volume |
M0 | Speaker always off |
M1 | Speaker on until carrier present |
M2 | Speaker always on |
M3 | Speaker off during dialing; speaker on until carrier present |
N0 | Handshake only at the communication standard specified by S37 and |
| ATB command |
N1 | Begin the handshake at the communication standard specified by s37 and ATB, |
| and fallback to lower speed may occur |
O0 | Return to data mode |
O1 | Retrain and return to data mode |
O3 | Rate |
PSelect pulse dialing
Q0 Enables result code
Q1 Disables result code
Sn | Select |
|
|
| - 18 - | Rev.1.00.2.1.34 |