Transition Networks SBFTF10XX-10X Compliance Information, Is the Link in the proper position?

Page 8

SBFTF10xx-10x

Troubleshooting -- Continued

2.Is the “Duplex/Link” LED illuminated on the twisted-pair copper port?

NO

Check the copper cables for proper connection.

Contact Tech Support: 1-800-260-1312, Int’l: 00-1-952-941-7600.

YES

Amber = The media converter has selected half-duplex mode.

Green = The media converter has selected full-duplex mode.

If the mode is not correct, disconnect and reconnect the twisted pair cable to restart the initialization process.

Proceed to step 3.

3.Is the “LACT” LED illuminated on the fiber port?

NO

Check the fiber cables for proper connection.

Verify that the TX and RX cables are connected to the RX and TX ports, respectively, on the 100Base-FX device.

Contact Tech Support: 1-800-260-1312, Int’l: 00-1-952-941-7600.

YES

Proceed to step 4.

4.Is the “Speed” LED illuminated on the twisted-pair cable port?

NO

Check the copper cables for proper connection.

Contact Tech Support: 1-800-260-1312, Int’l: 00-1-952-941-7600.

YES

Amber = The media converter has selected 10Mb/s operation.

Green = The media converter has selected 100Mb/s operation.

If the speed is not correct, disconnect and reconnect the twisted pair cable to restart the initialization process.

Proceed to step 5.

5.Is the Link in the proper position?

NO

The link may “flap” (go from “link up” to “link down”) when the link is lost (if the media converter has the Link Pass-Through function enabled and is in forced 10/100 Mb mode).

Contact Tech Support: 1-800-260-1312, Int’l: 00-1-952-941-7600.

YES

Contact Tech Support: 1-800-260-1312, Int’l: 00-1-952-941-7600.

Compliance Information

CISPR22/EN55022 Class A + EN55024

CE Mark

FCC Regulations

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at the user's own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications. Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la Class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

European Regulations

Warning This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Achtung! Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes Rundfunkstörungen auftreten, in diesem Fäll ist der Benutzer für Gegenmaßnahmen verantwortlich.

Attention! Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des interférences radioélectriques, il appartiendra alors à l'utilsateur de prende les measures spécifiques appropriées.

VCCI Class 1 Compliance

This equipment is in the 1st Class category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set by the Voluntary Control Council For Interference by Data Processing

Equipment and Electronic Office Machines aimed at preventing radio interference in commercial and/or industrial areas. When used in a residential area or in an adjacent area thereto, interference may be caused to radio and TV receivers, etc. Read the instructions for correct handling.

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG- Mitgliedstaaten verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

14

24-Hour Technical Support: 1-800-260-1312-- International: 00-1-952-941-7600

techsupport@transition.com -- Click the “Transition Now” link for a live Web chat.

15

Image 8
Contents User’s Guide Stand Alone Media ConverterInstallation Set the Configuration SwitchesConnect the Fiber Cable Power the Media ConverterConnect the Twisted-Pair Copper Cable Operation Using the Status LEDsProduct Features Bit Rule 100Base-TX or 100Base-FX Optional Accessories sold separatelyHalf-Duplex Network Half-Duplex Network Cable Specifications Fiber CableSegment Rule 10Base-T 100Base-TX Fiber ExampleTechnical Specifications TroubleshootingIs the power LED illuminated? Copper CableCompliance Information Is the Lact LED illuminated on the fiber port?Is the Link in the proper position? European RegulationsContact Us