ATTACHING THE MAGNETIC STARTER ON/OFF SWITCH
1.The Magnetic Starter on/off switch (A) Fig. 9 comes attached to a mounting bracket on the right side of the machine. Remove it.
2.Insert a
(A). Use a
3.Attach the side of switch bracket (A) Fig. 11 to the inside of the extension table using the
4.Tighten all hardware securely.
D
F |
| E |
G
A
C
A
Fig. 9
D
A
Fig. 10
Fig. 11
ATTACHING THE BLADE GUARD AND SPLITTER ASSEMBLY
DISCONNECT THE MACHINE FROM THE POWER SOURCE!
1.Remove the table insert Fig. 12. Raise the saw arbor by turning the height adjusting handle on the front of the saw
2.The inside splitter mounting bracket (A) Fig. 13 comes attached to the inside of the saw and was aligned with the inside blade flange (B) at the factory.
Fig. 12
Fig. 13
C
A
B
10