Delta 34-801 Assembly Tools Required, Assembly Time Estimate, Attaching The Extension Wing

422-04-651-0064 - 06-20-05.qxd 6/20/05 1:42 PM Page 8

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

1/8" Hex Wrench (Supplied)	5/16" Wrench
5/64" Hex Wrench (Supplied)	7/16" Wrench
1/2" Wrench	Flat-Head Screwdriver

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes approximately 1 hour.

For your own safety, do not connect the machine to the power source until the machine is completely assembled and you read and understand the entire instruction manual.

INSTALLING THE BLADE TILTING HANDWHEEL

1.Install the fiber washer (A) Fig. 3 on the shaft (B). Install the key (C) into the shaft keyway.

2.Place the handwheel (D) on the shaft (B) Fig. 3. Align the groove (E) in the handwheel with the key (C).

3.Push the handwheel snugly against the fiber washer and tighten the set screw.

4.Thread the lockknob (F) Fig. 4 into the shaft (B). Hand-tighten lock knob.

Fig. 3

A

E

D

B

C

B

F

Fig. 4

ATTACHING THE EXTENSION WING

NOTE FOR MAGNETIC STARTER BOX: Do not install the front screw and washer when you attach the left extension wing. You will install those when you attach the "ON/OFF" switch.

NOTE FOR LVC STARTER BOX: If your Unisaw was shipped with an LVC starter box, remove the LVC “ON/OFF” switch from the left side of the Unisaw. Save the hardware to attach the “ON/OFF” switch to the left extension wing in the section “ATTACHING THE LVC ON/OFF SWITCH.”

Attach the extension wing (A) Fig. 5 to the left side of the saw table using three 7/16"-20x11/4" hex head bolts (B) and 7/16" flat washers.

NOTE: Make sure that the front edge of the wing is flush with the front edge of the table.

A

B

Fig. 5

8