A
D
B
Fig. 14
A
F
Fig. 15
3.To check the alignment, remove the screw and fastener plate (C) Fig. 13. Use a straight edge (D) Fig. 14 to see if the splitter bracket (A) is aligned with the inside blade flange (B). Check both the top and bottom of bracket (A) with the top and bottom of flange (B).
4.To adjust, loosen the two screws (F) Fig. 15, and adjust splitter bracket (A) until it is aligned with the inside blade flange (B) Fig. 15. Tighten the two screws (F). Loosely install the screw and fastener plate (C), that were removed in STEP 3.
5.Insert the threaded end of the support rod (G) Fig. 16, through the slot in the rear of the saw and into the hole in the rear trunnion (H). Fasten the support rod
(G) to the trunnion with a star washer and hex nut (J) Fig. 17.
NOTE: Thread a nut (J) Fig. 17, on the threads of the support rod (G) as much as possible by hand.
6.Use a wrench to hold the hex nut (J) Fig. 17, insert a small screwdriver (K) through the hole in the end of the rod (G) Fig. 18, and tighten the rod (G) Fig. 18.
7.Attach the lower bracket (L) Fig. 19 the to rod (G). Loosely tighten with two
(L).
G
K
Fig. 18
H |
| G |
Fig. 16
J
Fig. 17
G
L
S
Fig. 19
11