When ripping material with a veneer facing that extends over the material, the fence (A) should be in the horizontal position with the veneer (B) extending over the lip of the fence, as shown in Fig. 53
When ripping material with a veneer facing and the material is not thick enough for the veneer to extend over the lip of the fence or if the veneer facing (B) is on both sides of the material, as shown in Fig. 54, the fence can be positioned slightly above the surface of the table. The veneer can be placed between the fence and the table or the veneer can straddle the fence with the material solidly against the fence.
B
A
Fig. 53
B
Fig. 54
RIPPING ON LEFT SIDE OF SAW BLADE
In some cases it may be desirable to use the fence on the left side of the saw blade. This is easily accomplished by repositioning the fence (A) Figs. 55 and 56, fence clamp bar (B), and lock knobs (C) so that the fence (A) will be attached to the right side of the fence body, as shown in Fig. 56. The complete fence assembly (D) Fig. 56, can easily be moved to the left side of the saw table.
A
C
B
C 
A
Fig. 55
D 
Fig. 56
20
