IBM CMX58886CX user manual Eide Connector CN101, Pin Signal

EIDE Connector (CN10)

The EIDE connector is a 44-pin, 2 mm connector that can connect to a variety of EIDE or IDE devices. The connector provides all signals and power needed to use a 2.5-inch form factor (laptop) hard drive. Also, the first 40 pins of the connector provide all of the signals needed to interface to a 3.5-inch or 5-inch form factor hard drive, CD-ROM drive, or other EIDE device. The larger form factors use a 40-pin, 0.1 inch spacing connector, so an adapter cable or adapter board is needed to connect to CN10.

Table 15 EIDE Connector (CN10)1

Pin	Signal	Pin	Signal
1	RESET#	2	GND
3	DD7	4	DD8
5	DD6	6	DD9
7	DD5	8	DD10
9	DD4	10	DD11
11	DD3	12	DD12
13	DD2	14	DD13
15	DD1	16	DD14
17	DD0	18	DD15
19	GND	20	N/C
21	DMARQ	22	GND
23	DIOW#:STOP	24	GND
25	DIOR#:HDMARDY#:HSTROBE	26	GND
27	IORDY:DDMARDY#:DSTROB	28	GND
29	DMACK#	30	GND
31	INTRQ	32	N/C
33	DA1	34	PDIAG
35	DA0	36	DA2
37	CS0#	38	CS1#
39	DASP#	40	GND
41	+5 V (logic)	42	+5 V (motor)
43	GND	44	N/C

1. Signals marked with (#) are active low.

32 CMX58886CX cpuModule BDM-610000050 Rev A