IBM VT470, VT676, VT670, VT575 manual Lift the front edge of the projector

3. Projecting an Image (Basic Operation)

￿Adjusting the Picture Size and Position

Place your projector on a flat level surface and ensure that the projector is square to the screen.

Lift the front edge of the projector to center the image vertically.

*If the projected image does not appear square to the screen then use the

Keystone feature for proper adjustment. See page 26.

Move the projector left to center the image horizontally on the screen.

Adjust the Tilt Foot

1.Lift the front edge of the projector.

2.Push up the Adjustable Tilt Foot Levers on the right and left sides of the projector to extend the adjustable tilt feet (maximum height).

1

Adjustable Tilt Foot Lever

2

2

Adjustable Tilt Foot

Adjustable Tilt

Foot Lever

3.Push down the Adjustable Tilt Foot Levers.

4.Lower the front of the projector to the desired height and release the Adjustable Tilt Foot Lever to lock the Adjustable tilt foot. There is approximately 10 degrees of up and down adjustment for the front of the projector.

CAUTION

Do not use the tilt-foot for purposes other than originally intended. Misuses such as gripping the tilt-foot or hanging on the wall can cause damage to the projector.

4

3

4

24