| 7. Appendix | |
Common Problems & Solutions (See also "Power/Status/Lamp Indicator" on page 53.) | ||
|
|
|
Problem | Check These Items |
|
Does not turn on | • Check that the power cable is plugged in and that the power button on the projector cabinet or the remote |
|
| control is on. See pages 20 and 21. |
|
| • Ensure that the lamp cover is installed correctly. See page 51. |
|
| • Check to see if the projector has overheated or the lamp usage exceeds 2100* hours (up to 3100* hours : Eco |
|
| mode). If there is insufficient ventilation around the projector or if the room where you’re presenting is par- |
|
| ticularly warm, move the projector to a cooler location. |
|
| * VT575 and VT47: 3100 hours (up to 4100 hours in Eco mode). |
|
| • The lamp may fail to light. Wait a full minute and then turn on the power again. |
|
| • The lamp has reached the end of its usable life. Replace the lamp. |
|
|
|
|
Will turn off | • Ensure that the Power Management is off. See page 45. |
|
|
|
|
No picture | • Use the VIDEO, the |
|
| Video or |
|
| • Ensure your cables are connected properly. |
|
| • Use menus to adjust the brightness and contrast. See page 38. |
|
| • Remove the lens cap. |
|
| • Reset the settings or adjustments to factory preset levels using the “Default” in the Menu. See page 47. |
|
| • Enter your registered keyword if the Security function is enabled. See page 42. |
|
| • When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning |
|
| on the power to the notebook PC. In most cases signal cannot be output from RGB output unless the notebook |
|
| PC is turned on after connecting with the projector. |
|
| * If the screen goes blank while using your remote control, it may be the result of the computer's screen- |
|
| saver or power management software. |
|
| • See also the next page. |
|
|
|
|
Picture suddenly | • When one of the following happens, the Lamp mode automatically changes from Normal to Eco. |
|
becomes dark | * When there are no signals (blue or black screen) → To return to the Normal mode, select another available |
|
| source. |
|
| * When the image is muted using the |
|
| again to return to the Normal mode. |
|
| * When the room where you' re presenting is particularly warm → Move the projector to a cooler location. |
|
|
|
|
Color tone or hue is | • Check if an appropriate color is selected in "Wall Color". If so, select an appropriate option. See page 37. |
|
unusual | • Adjust "Hue" in "Picture". See page 38. |
|
|
|
|
Image isn’t square to | • Reposition the projector to improve its angle to the screen. See page 24. |
|
the screen | • Use the Keystone correction function to correct the trapezoid distortion. See page 26. |
|
|
|
|
Picture is blurred | • Adjust the focus. See page 25. |
|
| • Reposition the projector to improve its angle to the screen. See page 24. |
|
| • Ensure that the distance between the projector and screen is within the adjustment range of the lens. See |
|
| pages 11 for VT676/VT670/VT575/VT470 and 12 for VT47. |
|
| • Condensation may form on the lens if the projector is cold, brought into a warm place and is then turned on. |
|
| Should this happen, let the projector stand until there is no condensation on the lens. |
|
|
|
|
Image is scrolling | • Use the VIDEO, the |
|
vertically, horizontally | Video or Computer). See page 23. |
|
or both | • Adjust the computer image manually with the Horizontal/Vertical in the “Advanced → Page 2”. See page 45. |
|
|
|
|
Remote control does | • Install new batteries.See page 10. |
|
• Make sure there are no obstacles between you and the projector. |
| |
not work | • Stand within 22 feet (7 m) of the projector. See page 10. |
|
|
|
|
Indicator is lit or | • See the POWER/STATUS/LAMP Indicator on page 53. |
|
blinking |
|
|
Cross color in RGB | • Press the AUTO ADJ. button on the projector cabinet or the remote control. See page 28. |
|
mode | • When “Off” is selected in Auto Adjust, adjust the computer image manually with Clock/Phase in “Advanced → |
|
| Page 2” in the menu. See pages 45 and 46. |
|
|
|
|
For more information contact your dealer.
54