
L i f e B o o k C S e r i e s N o t e b o o k B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA devices are installed.
*Note that actual hard drive label shown may vary. Depending on the drive type, information such as cylinders, heads and sectors may also be displayed.
PhoenixBIOS Setup Utility
Main
|
|
|
|
|
| Primary Master [FUJITSU | Item Specific Help |
| |
|
|
|
|
|
| Type: | [Auto] | Select ATA/ATAPI drive |
|
| LBA Format | installed here. |
| |
| Total Sectors: | 78140160 |
|
|
| Maximum Capacity: | 40008MB | [Auto] |
|
|
|
| The BIOS |
|
| [16 Sectors] | drive on boot time. |
| |
| LBA Mode Control: | [Enabled] |
|
|
| PIO Transfer Mode: | [Multiword DMA 2] | Except [Auto] |
|
| DMA Transfer Mode: | [Disabled] | You enter parameters of |
|
|
|
| the drive. |
|
|
|
| [None] |
|
|
|
| The drive is disabled. |
|
|
|
|
|
|
|
|
|
|
|
F1 | Help | Select | Item |
ESC | Exit | Select | Menu |
Change | Values | |
Enter | Select | ▲ |
F9 Setup Defaults
F10 Save and Exit
Figure 2. Primary Master Submenu
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field | Options | Default | Description |
|
|
|
|
Type: | • Auto | [Auto] | Selects the ATA/ATAPI device type. Select Auto to have the type |
| • None |
| automatically identified by the BIOS at POST. If None is selected, all |
| • |
| of the following |
| • Hard Disk |
| |
|
|
| |
|
|
| selected, you must specify the number of Cylinders, Heads, and Sec- |
|
|
| tors for the drive. |
|
|
|
|
CHS Format (Cylinders, Heads, Sectors) |
|
| |
|
|
|
|
Cylinders: | • A number | This appears only when Hard Disk is selected. When Hard Disk is | |
| between 0 and |
| selected, you can change the value. This field is incremented by |
| 65,535 |
| pressing the [Spacebar]). This field is decremented by pressing the [- |
|
|
| |
|
|
| ] key. You can also change the field by typing in the number. |
|
|
|
|
Heads: | • A number | This appears only when Hard Disk is selected. When it is selected, | |
| between |
| you can change the value. This field is incremented by pressing the |
| 1 and 16 |
| [Spacebar]). This field is decremented by pressing the |
|
|
| |
|
|
| field can also be changed by typing in the number. |
|
|
|
|
6