IBM SAGP-845EV Boot Up NumLock Status, Gate A20 Option, Typematic Rate Setting, Security Option

Boot Up NumLock Status

Select power on state for NumLock.

The choice: On/Off.

Gate A20 Option

Select if chipset or keyboard controller should control GateA20.

Normal	A pin in the keyboard controller controls
	GateA20
Fast	Lets chipset control GateA20

Typematic Rate Setting

Key strokes repeat at a rate determined by the keyboard controller. When enabled, the typematic rate and typematic delay can be selected.

The choice: Enabled/Disabled.

Typematic Rate (Chars/Sec)

Sets the number of times a second to repeat a key stroke when the key has been held down.

The choice: 6, 8, 10, 12, 15, 20, 24, 30.

Typematic Delay (Msec)

Sets the delay time after the key is held down before it begins to repeat the keystroke.

The choice: 250, 500, 750, 1000.

Security Option

Select whether the password is required every time the system boots or only when the user enters setup.

System	The system will not boot and access to Setup will
	be denied if the correct password is not entered at
	the prompt.
Setup	The system will boot, but access to Setup will be
	denied if the correct password is not entered at the
	prompt.

Note: To disable security, select PASSWORD SETTING at Main Menu and then the user will be asked to enter password. Do not type anything and just press <Enter>, it will disable security. Once the security is disabled, the system will boot and Setup page can be accessed freely.

OS Select For DRAM > 64MB

Select the operating system running with greater than 64MB of RAM on the system.

The choice: Non-OS2, OS2.

27