IBM DAS16AO manual Calibrating the PC-CARD-DAS16/16AO, Field wiring and signal termination

PC-CARD-DAS16/16AO User's Guide			Installing the PC-CARD-DAS16/16AO
C50FF-x
2	1	The red stripe	2	1
		identifies pin # 1

50	49	50	49
50-pin female		50-pin female
IDC connector		IDC connector

Figure 8. C50FF-xcable

Details on the C50FF-x cable are available on our web site at

www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=104&pf_id=136.

Field wiring and signal termination

You can use the following cabling, screw termination, and signal conditioning products with the CPCC-50F-39 cable, or with the CPCC-50M-4 and C50FF-x cables:

ƒCIO-MINI50 – 50-pin screw terminal board. Details on this product are available on our web site at www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=102&pf_id=258.

ƒSCB-50 – 50 conductor, shielded signal connection/screw terminal box provides two independent 50-pin connections. Details on this product are available on our web site at www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=196&pf_id=1168.

Information on signal connections

General information regarding signal connection and configuration is available in the Guide to Signal Connections (available at www.mccdaq.com/signals/signals.pdf).

Calibrating the PC-CARD-DAS16/16AO

The PC-CARD-DAS16/16AO features auto-calibration with InstaCal. Calibration coefficients for each range are stored on board in nonvolatile RAM. The normal calibration interval is once per year.

15