Fujitsu D1961 technical manual System battery is dead Replace and run Setup

Page 44

Error messages

System battery is dead - Replace and run SETUP

Replace the lithium battery on the mainboard and redo the settings in the BIOS Setup.

System Cache Error - Cache disabled

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

System CMOS checksum bad - - Default configuration used

Call the BIOS Setup and correct the previously made entries or set the default entries.

System Management Configuration changed or Problem occurred

A system fan or system sensor has failed. Check the hardware operation.

System timer error

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

Uncorrectable ECC DRAM error

DRAM Parity error

Unknown PCI error

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

Verify CPU frequency selection in Setup

The frequency setting for the processor is invalid. Correct the BIOS Setup and the setting.

34 - English

A26361-D1961-Z120-1-7419, edition 2

Image 44
Contents Answers EnglishSie haben Page A26361-D1961-Z120-1-7419 Ausgabe Januar January 2005 edition Mainboard D1961Technisches Handbuch Technical Manual Page Übersicht/Overview Mainboard D1961 11 10Page Contents Page Notational conventions Additional informationImportant notes Information about boardsSpecial onboard features List of featuresOnboard features Internal ports External portsSpecial features Brief instructions on installing mainboard Prior to installationInstallation Driver installationInterfaces and connectors External portsLAN port LED 1 greenInternal ports and connectors Or 6-channel audio mode via analogue audio channelsHard disk connection Audio front panelUsing external audio connections Selecting settings for 2, 4 or 6-channel audio modeAnalogue 2-channel audio output Analogue 4-channel audio outputAudio Pin assignment of internal portsFront panel Fan 1 Audio front panelUSB dual channel Floppy interface ATA interface Power supply BTX Additional power supply ATX12Settings with switches and jumpers Setting via control-panel plug connectorSkipping system and Bios Setup password pinpair a Recovering System Bios pinpair BInstalling processor with heat sink Technical dataAdd-on modules / Upgrading Replacing the processorReplacing the processor Mounting heat sink Installing a memory module Upgrading main memoryRemoving a memory module Upgrading AGP screen controllersAdding PCI cards Monofunctional expansions cards PCI bus interrupts Selecting correct PCI slotAudio Modem Replacing the lithium battery Bios update under Windows with DeskFlash utility Bios updateWhen should a Bios update be carried out? Bios Recovery Recovering System Bios When should a microcode update be carried out? Microcode UpdateWhat is a microcode update? Drivers Annex Electrical PropertiesLoadability for connections and fuses Mainboard current requirementAPM and Acpi system status, energy-saving modes LEDMainboard Revision Mainboard Revision and Bios VersionBios version Error messages Bios update for installed CPU failedError messages Monitor type does not match Cmos RUN Setup System battery is dead Replace and run Setup Glossary