IBM 8183 manual Laser compliance statement

Page 13

vLes prises téléphoniques ne doivent pas être installées dans des endroits humides, excepté si le modèle a été conçu à cet effet.

vNe touchez jamais un cordon téléphonique ou un terminal non isolé avant que la ligne ait été déconnectée du réseau téléphonique.

vSoyez toujours prudent lorsque vous procédez à l’installation ou à la modification de lignes téléphoniques.

vSi vous devez téléphoner pendant un orage, pour éviter tout risque de choc électrique, utilisez toujours un téléphone sans fil.

vEn cas de fuite de gaz, n’utilisez jamais un téléphone situé à proximité de la fuite.

Laser compliance statement

Some IBM Personal Computer models are equipped from the factory with a CD-ROM drive or a DVD-ROM drive. CD-ROM drives and DVD-ROM drives are also sold separately as options. CD-ROM drives and DVD-ROM drives are laser products. These drives are certified in the U.S. to conform to the requirements of the Department of Health and Human Services 21 Code of Federal Regulations (DHHS 21 CFR) Subchapter J for Class 1 laser products. Elsewhere, these drives are certified to conform to the requirements of the International Electrotechnical Commission (IEC) 825 and CENELEC EN 60 825 for Class 1 laser products.

When a CD-ROM drive or a DVD-ROM drive is installed, note the following handling instructions.

CAUTION:

Use of controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure.

Removing the covers of the CD-ROM drive or DVD-ROM drive could result in exposure to hazardous laser radiation. There are no serviceable parts inside the CD-ROM drive or DVD-ROM drive. Do not remove the drive covers.

Some CD-ROM drives and DVD-ROM drives contain an embedded Class 3A or Class 3B laser diode. Note the following statement.

DANGER

Laser radiation when open. Do not stare into the beam, do not view directly with optical instruments, and avoid direct exposure to the beam.

DANGER:

Certains modèles d’ordinateurs personnels sont équipés d’origine d’une unité de CD-ROM ou de DVD-ROM. Mais ces unités sont également vendues séparément en tant qu’options. L’unité de CD-ROM/DVD-ROM est un appareil à laser. Aux État-Unis, l’unité de CD-ROM/DVD-ROM est certifiée conforme aux normes indiquées dans le sous-chapitre J du DHHS 21 CFR relatif aux produits à laser de classe 1. Dans les autres pays, elle est certifiée être un produit à laser de classe 1 conforme aux normes CEI 825 et CENELEC EN 60 825.

Lorsqu’une unité de CD-ROM/DVD-ROM est installée, tenez compte des remarques suivantes:

Important safety information

xi

Image 13
Contents User Guide Types 8183, 8184, 8320 Types 8417, 8418, 8419 Page User Guide Types 8183, 8184, 8320 Types 8417, 8418, 8419 Page Contents Iv User Guide Conditions that require immediate action Important safety informationService General safety guidelinesPower cords and power adapters Plugs and outlets Extension cords and related devicesBatteries Additional safety information CD and DVD drive safetyHeat and product ventilation To connect To disconnect Modem safety information Lithium battery noticeLaser compliance statement Xii User Guide Information resources OverviewSystem summary FeaturesExpansion Available options Environment SpecificationsSupported operating positions Installing external options Installing optionsHandling static-sensitive devices Cover keylock some models Obtaining device drivers Locating connectors on the rear of your computerOpening the cover Locating components Accessing system board components and drives Identifying parts on the system board Installing memory Installing PCI adapters What to do next Installing internal drivesSerial ATA IDE hard disk drive Removing and replacing a CD-ROM, CD-RW, or DVD optical drive Removing and replacing a hard disk drive Removing and replacing a diskette drive Connecting a serial ATA hard disk driveInstalling security features Connecting an IDE driveIntegrated security cable Identifying security locksInstalling options Rope clip Password protectionCover lock Closing the cover and connecting the cables Erasing a lost or forgotten password clearing CmosUser Guide Starting the IBM Setup Utility program Using the IBM Setup UtilityViewing and changing settings Using passwords Exiting from the IBM Setup Utility programUser password Administrator passwordUsing IDE Drives Setup Using Security Profile by DeviceSelecting a startup device Advanced settingsSelecting a temporary startup device Changing the startup device sequenceAppendix A. Replacing customer replaceable units CRU CRU list Removing and replacing the power supply assembly User Guide Appendix A. Replacing customer replaceable units CRU Removing and replacing the system board assembly Disconnect all other cables connected to the system board Removing the microprocessor Appendix A. Replacing customer replaceable units CRU Replacing the microprocessor Removing and replacing the battery Removing and replacing the speaker Speaker, fan, power button and LED assembly Removing and replacing the power button and LED assemblyRemoving and replacing the fan assembly Appendix A. Replacing customer replaceable units CRU Completing the installation Updating flashing Bios from a diskette Appendix B. Updating POST/BIOSUpdating flashing Bios from your operating system Recovering from a POST/BIOS update failure Cleaning an optical mouse Appendix C. Cleaning the mouseCleaning a mouse with a ball User Guide Basic AT commands Appendix D. Manual modem commandsLow speaker volume Enable RTS/CTS hardware flow control Extended AT commands+MS=? MNP/V.42/V.42bis/V.44 commandsFax Class 2 commands Fax Class 1 commandsVoice commands Appendix D. Manual modem commands User Guide Appendix E. Notices IBM TrademarksCRU Index Special charactersPOST/BIOS Page Part Number 13R9208
Related manuals
Manual 76 pages 20.24 Kb