Fujitsu MB3887 Processing Without Using of the Error AMP, Connection when Error Amp is not used

Page 22

MB3887

■PROCESSING WITHOUT USING OF THE ERROR AMP

When Error Amp is not used, leave FB1 terminal (pin 7) , FB2 terminal (pin 5) open and connect the −INE1 terminal (pin 8) and −INE2 terminal (pin 4) to GND and connect +INE1 terminal (pin 9) , and +INE2 terminal (pin 3) , to VREF.

	9	+INE1	GND	23
	3	+INE2
	8	−INE1
	4	−INE2
“Open”	7	FB1
“Open”
	5	FB2

6 VREF

Connection when Error Amp is not used

22

Image 22

Contents Description FeaturesPackage MB3887 PIN Assignment TOP ViewPin No Symbol Descriptions PIN DescriptionBlock Diagram Parameter Symbol Conditions Rating Unit Min Max Absolute Maximum RatingsParameter Symbol Conditions Value Unit Min Typ Recommended Operating ConditionsParameter Sym Pin Conditions Electrical CharacteristicsBol Min Typ Parameter Sym Pin Conditions Value Unit Bol Min Typ Max Parameter Sym Pin Conditions Value Unit Bol Min Typ OUT = −45 mA Output block Resistor Typical Characteristics Triangular wave oscillation frequency fOSC kHz Error amplifier gain and phase vs. Frequency Gain a Power dissipation vs. Ambient temperature Functional Description Output block OUT PowerPWM comparator block PWM Comp Control block CTLMethod of Setting the Triangular Wave Oscillation Frequency Setting the Charging VoltageMethod of Setting the Charging Current Soft-start block SoftMethod of Setting the SOFT-START Time Operation Timing Diagram AC Adaptor Voltage DetectionProcessing Without Using the Current AMP Connection when Current Amp is not usedProcessing Without Using of the Error AMP Connection when Error Amp is not usedProcessing Without Using of the CS Terminal Connection when soft-start time is not specifiedApplication Example At 4 cellParts List Parts NoReference Data Batt Vbatt mV Ta = +25 C, VIN = 19 Batt = 12 Ω Ordering Information Usage PrecautionsPart number Package Remarks Package Dimension IndexFujitsu Limited