Fujitsu MB91360 manual Overview of Jumpers, Jumper Description Standard Setting Jumper Position

STARTERKIT MB91360

Chapter 6 Evaluation Board Hardware

The evaluation board provides various IO-signals, which can be connected to external devices. The controller resource functions are available on the connectors JP14, JP15, JP16 and JP20.

External peripheral devices can be connected via the address/data bus on JP24 and JP25. For more information please refer to the following pin assignments and the schematics in the appendix.

6.2Overview of Jumpers

Jumper	Description	Standard Setting ￿	Jumper Position
JP1	Main Vcc Net for MCU	Closed (Vcc supplied)	Closed
JP2	32kHz-Oscillator	GND (X0A disabled)	(2-3 closed) Right
JP3	4 MHz-Oscillator	X0 (Active)	(1-2 closed) Left
JP4	LPF for 32kHz-Oscillator	Vcc (Enabled)	(2-3 closed) Up
JP5	Clock Select Pin	Vcc (4 MHz)	(2-3 closed) Up
JP6	Hardware Standby Pin	Vcc (Disabled)	(2-3 closed) Up
JP7	Select Source MD0	Vcc (PAL)	(2-3 closed) Up
JP8-10	Test Mode Enable	Open (no test mode)	Open
JP13	LED enable	Closed (LEDs active)	Closed
JP17-19	Analog Supply Voltage	Closed (A/D active)	Closed
JP22-23	Driver Supply Voltage	Closed (Driver active)	Closed
JP26	Serial Output 0 enable	Closed (enabled)	Closed
JP27	Serial Input 0 enable	Closed (enable)	Closed
JP28-29	CAN0 driver enable	Closed (enable)	Closed
JP30,31	USER-buttons enable	Closed (enable)	Closed
JP32	Ext. UART int. enable	Open (disable)	Open
JP33	DTR reset enable	Open (disable)	Open
JP34	Power-up mode	GND (Monitor mode)	(1-2 closed) Down
MD2	Mode-Pin 2	GND	On (Upper Dip Pos)
MD1	Mode-Pin 1	GND	On
MD0	Mode-Pin 0	GND	On
BOOT	Boot-Pin	GND	On

Table 1: Selection jumpers on MB91360 Starterkit

© Fujitsu Microelectronics Europe GmbH - 23 - UG-910006-13