Fujitsu MB91360 manual Hardware Installation

STARTERKIT MB91360

Chapter 2 Installation

2 Installation

2.1Hardware Installation

What you’ll need :

<Host : IBM(-comp) PC with Windows 9x or Windows NT ; 1 COM-port

<Power Requirements: A power supply, capable of supporting 9-12V DC at about 500 mA. Note that the power connector must be + at the shield and - in the centre. Power supplies are available from Fujitsu.

<RS232 : An ‘extension’ (1:1) RS232 cable with DB9 m+f connectors

Connect the power-supply (9-12V DC-input) and the RS232-cable

and switch on the Starterkit.

LED D10 should light up (power-indicator)

and LED D11 flashing (reset indicator). During the initialization phase

the red monitor LED is on.

After that, a start message from the monitor (“91360-STARTERKIT MONITOR VxLx”) will be displayed on the LCD and the green user LED will light up.

The board is now ready to use.

© Fujitsu Microelectronics Europe GmbH - 9 - UG-910006-13