Repositioning the Shipping Lock
To keep the scanner from being damaged during shipping, the carrier unit is fixed with a Shipping Lock. After placing the carrier unit where it will be installed, change the position of this Shipping Lock as explained below.
1Place the image scanner on the edge of the desktop so that the left side of the scanner (where the ADF is attached) extends from the desktop. Do not set the image scanner upside down or on its side.
CAUTION
Do not let the scanner hang more than 20 cm (8 in.) over the edge of the desk.
Good
less than 20 cm | Bad | Bad |
(8 in.) |
|
|
2 Remove the shipping lock from position | A . Then, install the shipping lock at position B . | |
Front side
Bottom view |
|
Shipping Lock |
|
(Position for storage, | ADF side |
position for shipment) |
|
Enlarged section A |
|
Front side
Enlarged
Shipping Lock (Position for operation)
B
A
Shipping Lock (Position for shipment)
CAUTION
Before moving or storing the scanner, make sure that the shipping lock is set to the shipment position to prevent possible damage. Before setting the shipping lock, make sure that the carrier has been returned to the home position.
