Fujitsu 15C user manual Connecting the Cable Turning the Power Off, Ii. Turning the Power On

Page 13

2.7Connecting the Cable

i). Turning the Power Off

Depress the side marked “O” to turn the power off.

Connect the power cable and SCSI signal cable as shown in Figure 2-8.

ii). Turning the Power On

Depress the side marked “I” to turn the power on. The POWER LED will light. If not, please check the power source.

iii). SCSI Termination

The Fujitsu Scanpartner 15C comes complete with a built in SCSI terminator. If the Scanner is the last device in a SCSI chain the terminator should be switched on. If the Scanner is not the last device the terminator should be off. The terminator on/off switch is located on the back of the Scanner, to the left of the SCSI cable connectors.

Host PC

Term.

Scanner

SCSI Device

Term.

(Terminator Off)

Host PC

Term.

Scanner

(Terminator On)

2-9

Image 13

Contents Scanpartner 15C Image Scanner Table of Contents Introduction Scanner packing Precautions Installation and ConnectionsShipping Bracket Removing the Shipping Bracket refer to figures 2-1Removing the Shipping Bracket Scsi Interface Device ID Refitting the Shipping BracketAdjusting the Scsi ID setting ADF Paper Chute Figure Setting the ADF Paper ChuteADF Output Tray Figure Install the ADF Output Paper TrayPlace Document on the Scanner Document LoadingUse ADF to Load Multiple Documents ADF ScanningIi. Turning the Power On Connecting the Cable Turning the Power OffIii. Scsi Termination Scanpartner 15C Scanner Cable Connection Cleaning the ADF MaintenanceOpening the ADF unit and Document Cover Cleaning Area Cleaning the Glass The proceduresQuestion and Answer TroubleshootingPage ADF Paper Jam Opening the ADF Paper Jam in the ADFADF Paper Jam Removing the Paper Specifications Scanpartner 15C Specifications