ENGLISH
Connecting your monitor
Be sure to read the Safety Information located in the Monitor Safety and Warranty Information Manual before carrying out this procedure.
1.Turn off your computer and all attached devices. Next, unplug all power cords to your computer and all attached devices.
2.Connect the signal cable.
•The analog signal cable is already connected to your monitor
(See 
in Figure A).
•When connecting the analog signal cable, connect the free end of the attached signal cable to the 
Figure A
•If you are connecting a
Connect one end of the monitor signal cable to the white connector 
on the rear panel of the monitor. Connect the other end to the white connector 
on the rear panel of the computer and tighten the screws.
Figure B | 9 |
|