IBM L180p manual Switching on your monitor

Page 12

3.Connect the power cord to the monitor and then plug the power cord into a properly grounded outlet. Next, reconnect the power cords to your computer and all attached devices.

Switching on your monitor

1.Switch on your computer.

2.Switch on your monitor by pushing and releasing the power switch marked " " at the front of the bezel.

To switch off your monitor, push and release the power switch again.

3.To update or install device drivers, follow the instructions in the Device driver installation section on page 11.

4.If you are using the analog connector, run Image setup by following the instructions in the Automatic Image setup section on page 14.

10

Image 12
Contents L180p First Edition January/2004 Contents Page English Page Setting up the monitor Product descriptionHandling instructions Kensington security slot Figure aAdjusting the monitor position Workplace preparationCaring for your monitor Connecting your monitor Figure aSwitching on your monitor Device driver installation Installing the device driver in Windows 95 or WindowsInstalling the device driver in Windows 2000 or Windows Me Installing the device driver in Windows XP Automatic Image setup Image setupImage setup for DOS Operating system installation steps Step System Manual Image setup Adjusting your LCD monitor Icon Direct Access FunctionsUser controls Icon Monitor controlsOn-screen display OSD controls Initial appearance of OSDPreset OSD Icon Description Sub-menus Further information Display modesPower management Product disposalMove the mouse TAR Arm or wall mounting Removing the stand and cablesTroubleshooting Problem Possible Suggested Action Reference CauseCheck Help and service information Specifications With StandService information Description Video ColorGeography Page Trademarks