Arm or wall mounting, Removing the stand and cables

Arm or wall mounting

Removing the stand and cables

iBe sure to read the Monitor Safety and

Warranty Information manual that comes with your monitor before changing stands or cables.

Alternative stands for your IBM Flat Panel Monitor may be available from specialist suppliers.

This product is equipped with mounting facilities that conform to the VESA Flat Panel Monitor Physical Mounting Interface Standard (FPMPMI). When using the VESA standard mounting plate, connect the monitor to the wall or to the arm mounting device. Use other cables for reasons such as having the monitor wall-mounted, follow the instructions below:

1.Power off the monitor. Next, disconnect the power cord and then the signal cable to the monitor.

2.Lay the monitor facedown on a cushion and remove the four screws holding the hinge mechanism on the monitor. Refer to the diagram below for additional information on how to remove the stand.

3.You have to use the four screw holes on the bottom of the stand to attach the monitor to the surface of wall. For additional information, see the instructions supplied with the purchased arm.

4.Locate a place to which you want to attach the monitor. When locating the place, you have to consider the lengths of the signal cable and the power cord.

5.Place the monitor in the location you selected in the step 4.

Next, reconnect the signal cable and then the power cord to the monitor. To obtain the correct cables and/or to get further instructions on installing them, call the IBM Support Center at the above numbers or contact your dealer, retailer, or other IBM authorized service representative.