Cisco Systems CATALYST 2950 manual DHCP-enabled PC

Page 5

Step 7 Connect a straight-through Category 5 Ethernet cable (not provided) to any 10/100 or 10/100/1000 Ethernet port on the switch front panel and to the Ethernet port on the PC.

DHCP-enabled PC

Step 8 Verify that the LEDs on both Ethernet ports are green.

Step 9 Wait 30 seconds.

Step 10 Launch a web browser on your PC. Enter the IP address 10.0.0.1 in the web browser, and press Enter.

Step 11 The Express Setup page appears. If it does not appear, see the “In Case of Difficulty” section on page 19 for help.

5

Image 5
Contents Catalyst 2950 Switch Getting Started Guide Taking Out What You Need Equipment That You Supply to Run Express SetupAbout this Guide Shipping Box Contents Running Express Setup DHCP-enabled PC Page Refreshing the PC IP Address Managing the SwitchUsing the Device Manager Other Management Options Command-Line InterfaceDownloading Cisco Network Assistant Before You Begin Rack-MountingEquipment That You Supply Installation Warning Statements Connector cover on the back of the switch. Statement Front-mounting position Attaching the BracketsRack-Mount the Switch Connect to 10/100 and 10/100/1000 Ports Connect to the Switch PortsInstall SFP and Gbic Modules and Connect to the Ports Ground the Switch Connecting to DC PowerWiring the DC Input Power Source Return Feed a Negative Negative Feed B Case of Difficulty Troubleshooting Express SetupAccessing Help Online Resetting the SwitchFor More Information Obtaining DocumentationDocumentation Feedback Cisco.comOrdering Documentation Cisco Technical Support Website Submitting a Service RequestObtaining Technical Assistance Obtaining Additional Publications and Information Definitions of Service Request SeverityCisco Limited Lifetime Hardware Warranty Terms Duration of Hardware Warranty Page USA