Supervisor Engine V
•Supervisor engine redundancy between primary and standby supervisor engines in Catalyst 4510R and Catalyst 4507R
•802.1Q tunneling
•Storm control in hardware
•Support for the Catalyst 4500 Series NetFlow Services Card
When the Supervisor Engine V is used in a Catalyst 4510R, slot 10 is a
Features of the Supervisor Engine Front Panel
The following sections describe the LEDs, connectors, and switches on the Catalyst 4500 series Supervisor Engine V:
•LEDs, page 9
•Gigabit Ethernet Uplink Ports, page 10
•Ethernet Management Port, page 10
•Console Port, page 10
•Reset Button, page 10
•Flash Port, page 11
LEDs
Table 1 describes the LEDs on the supervisor engine front panel.
Table 1 | Supervisor Engine LEDs | ||
|
|
|
|
LED |
| LED Status | Description |
|
|
|
|
STATUS |
|
| Indicates the results of a series of |
|
| Green | All diagnostic tests passed. |
|
| Red | A test failed. |
|
| Orange | System boot or diagnostic test is in progress. |
|
| Off | Module is disabled. |
|
|
| |
UTILIZATION | Green | If the switch is operational, this display indicates the current | |
|
|
| traffic load over the backplane (as an approximate percentage). |
|
|
|
|
Link |
|
| Indicates the status of the |
|
|
| port or uplink ports. |
|
| Green | The link is operational. |
|
| Orange | The link is disabled by user. |
|
| Flashing orange | The |
|
| Off | No signal is detected or there is a link configuration failure. |
|
|
|
|
Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V
| 9 |
| |
|
|