Cisco Systems WS-X4516 specifications Supervisor Engine

Page 7

Supervisor Engine V

Supervisor Engine V

This section describes the Catalyst 4500 series Supervisor Engine V (WS-X4516). See Figure 1. This supervisor engine provides data path and data control for all network interfaces.

The Supervisor Engine V is supported in the Catalyst 4006, 4503, 4506, 4507R, and 4510R switches. On the Catalyst 4006, 4503, and 4506 switches, you can install the Supervisor Engine V only in slot 1. On the Catalyst 4507R or 4510R switch, you install the primary supervisor engine in slot 1, and you can install an optional redundant supervisor engine in slot 2.

The supervisor engine is hot swappable, but packets are not forwarded when the supervisor engine has been removed from the switch. When a supervisor engine is reinserted into the switch, the system reboots.

Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V

 

78-15590-02

7

 

 

 

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Contents Conservez CES Informations Safety OverviewBewaar Deze Instructies Säilytä Nämä OhjeetGuarde Estas Instruções Bewahren SIE Diese Hinweise GUT AUFConservare Queste Istruzioni TA Vare PÅ Disse InstruksjoneneSpara Dessa Anvisningar GEM Disse Anvisninger Page Supervisor Engine Catalyst 4500 Series Supervisor Engine V WS-X4516 LED Features of the Supervisor Engine Front PanelGigabit Ethernet Uplink Ports Maximum Cable Distances Port Cabling SpecificationsGbic Using a Patch CordRequired Tools Installing and Removing the Supervisor EnginePreventing Electrostatic Discharge Damage Installing the Supervisor Engine Chassis sides Removing the Supervisor Engine Captive Installation Screws and Ejector LeversAttaching Module Interface Cables RJ-45 ConnectorGbic Handling Guidelines and Installation Configuring Your Supervisor EngineInstalling a Gbic Removing a Gbic Installing a GbicRelated Documentation Gbic Maintenance GuidelinesRelated Documentation
Top Page Image Contents