Cisco Systems WS-X4516 specifications Gigabit Ethernet Uplink Ports

Supervisor Engine V

Table 1	Supervisor Engine LEDs (WS-X4516) (Continued)
LED		LED Status	Description
Active			Indicates whether the uplink port is active.
		Green	The port is active.
		Off	The port is not active.
ACTIVE			The LED to the right of the uplink ports is used to identify the
			active supervisor in switches with two supervisors.

Gigabit Ethernet Uplink Ports

The Gigabit Ethernet uplink ports operate in full-duplex mode only. These ports use the 1000BASE-T, 1000BASE-SX, 1000BASE-LX/LH, 1000BASE-ZX, CWDM, and DWDM Gigabit Interface Converters (GBICs). The GBICs have SC connectors to interface with multimode fiber (MMF) and single-mode fiber (SMF) cable. For further information on GBICs, see the “GBIC Handling Guidelines and Installation” section on page 18.

When two Supervisor Engine Vs are present in a Catalyst 4510R or Catalyst 4507R switch, all four uplinks are active on both the primary (active) and secondary (standby) supervisor engines by default, or two uplinks will be active in a nonredundant configuration. When using the Supervisor Engine V, slot

10(the Flex-Slot) in the Catalyst 4510R switch supports the 2-port Gigabit Ethernet switching module (WS-X4302-GB) or the Access Gateway Module (WS-X4604-GWY).

Ethernet Management Port

The Ethernet management port is used (in ROMMON mode only) to recover a switch software image that has been corrupted or destroyed due to a network catastrophe. This port is not active while the switch is operating normally.

Console Port

The Catalyst 4500 series Supervisor Engine V console port has an EIA/TIA-232 RJ-45 connector. The console port allows you to perform the following functions:

•Configure the switch from the CLI

•Monitor network statistics and errors

•Configure SNMP agent parameters

Note EIA/TIA-232 was known as recommended standard RS-232 before its acceptance as a standard by the Electronic Industries Alliance (EIA) and Telecommunications Industry Association (TIA).

Reset Button

The Reset button is used to restart the switch.

Note Use a paper clip or other small, pointed object to press the Reset button.

Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V

10 78-15590-02