Fujitsu Siemens Computers TX120 manual Batteries

Page 16

Safety

VCAUTION!

●Proper operation of the system (in accordance with

IEC 60950-1/EN 60950-1) is only ensured if the casing is completely assembled and the rear covers for the installation slots have been fitted (electric shock, cooling, fire protection, interference suppression).

●Only install system expansions that satisfy the requirements and rules governing safety and electromagnetic compatibility and those relating to telecommunication terminals. If you install other expan- sions, they may damage the system or violate the safety regulations. Information on which system expansions are approved for installation can be obtained from our customer service center or your sales outlet.

●The components marked with a warning notice (e.g. lightning symbol) may only be opened, removed or exchanged by authorized, qualified personnel. Exception: hot-pluggable power supply units can be replaced.

●The warranty is void if the server is damaged during installation or replacement of system expansions.

●Only set screen resolutions and refresh rates that are specified in the operating manual for the monitor. Otherwise, you may damage your monitor. If you are in any doubt, contact your sales outlet or customer service center.

Batteries

VCAUTION!

●Incorrect replacement of batteries may result in a risk of explosion. The batteries may only be replaced with identical batteries or with a type recommended by the manufacturer (see the technical manual for the system board).

●Replace the lithium-battery on the system board in accordance with the instructions in the technical manual for the system board.

16

Options Guide

TX120

Image 16

Contents Primergy TX120 Server Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOContents Contents Introduction Concept and target groupsDocumentation overview Documentation overviewIntroduction Further sources of informationExpansions and conversions Notational conventions Page Procedure Page Safety Safety Before starting up Installation and operationSafety Batteries Laser information Safety Working with CDs/DVDs and CD/DVD drivesNever remove parts of the CD/DVD drive casing Safety Modules with electrostatic-sensitive components ESD labelPreparation Opening the serverRemoving the crosspiece Removing the crosspiece PreparationDisconnecting the cables Removing the drive cageRemoving the drive cage Preparation Removing the drive cageMain memory Equipping rulesEquipping rules ModeMain memory Expanding/replacing the main memoryRemoving a memory module Installing a memory module Expanding/replacing the main memoryAccessible drives Installing an HDD extension boxInstalling an HDD extension box Fixing the rails on the HDD extension boxAccessible drives Installing an HDD extension boxRemoving the dummy cover from the top cover Installing a backup drive Installing a backup drive Fixing the rails on the backup driveUnfasten the cable clamp Connecting the USB and power cables to the backup drive Close the server see section Assembling the server on Page Expansion cards in the PCI slots PCI slot overviewInstalling an expansion card Installing an expansion cardInstalling an expansion card Closing the lock and fastening the slot cover Installing the drive cage CompletionInstalling the drive cage Connecting the cablesInstalling the crosspiece CompletionAssembling the server Assembling the serverAppendix CablingCabling AppendixAppendix CablingPower cable SAS backplane, backup drive and CD/DVD drive Cabling fan, control panel front panel TX120 Data and signal cable SAS backplane and CD/DVD drive A3C40083128 A3C40083120 A3C40085241 A3C40083117 A3C40083119 Abbreviations Abbreviations IRMC LCD ROM SSU Index Server